Endress+Hauser iTEMP TMT162 Kurzanleitung Seite 41

iTEMP TMT162
4.3 Display mounting
1
 19 4 display installation positions, attachable in 90° stages
1 Cover clamp
2 Housing cover with O-ring
3 Display with retainer and twist protection
4 Electronics module
1. Remove the cover clamp (1).
2. Unscrew the housing cover together with the O-ring (2).
3. Remove the display with twist protection (3) from the electronics module (4). Fit the
display with retainer in the desired position in 90° stages and plug it into the correct slot
on the electronics module.
4. Then screw the housing cover together with the O-ring.
5. Fit the cover clamp (1) back on.
Endress+Hauser
90°
2
3
90°
90°
90°
Installation instructions
4
A0025417
41