EINHELL TC-RA 18 Li BT Originalbetriebsanleitung Seite 16

5. Operation
5.1 Charging the LI battery pack (Fig. 3-4)
1. Remove the battery pack (3) from the unit by
pressing the pushlock button (4) downwards.
2. Check that your mains voltage is the same
as that marked on the rating plate. Insert the
power plug of the charger (5) into the socket
outlet. The green LED will then begin to fl ash.
3. Push the battery pack onto the battery char-
ger.
In section 9 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.2 Switching on/off
To switch on the unit, move the On/Off switch to
„I".
To switch off , move it to „0".
5.3 Setting the time (Fig. 6)
1. To set the time, switch the radio off and then
press „Clock" (H) until the indicator fl ashes.
2. Now you can set the hours using the „Volume
-" button (F) and the minutes using the „Volu-
Anl_TC_RA_18_Li_BT_Solo_SPK9.indb 15 Anl_TC_RA_18_Li_BT_Solo_SPK9.indb 15
GB
me +" button (E).
3. Now press the „Clock" (H) button again to
save the settings.
5.4 Button functions AM/FM and Bluetooth®
mode
AM/FM radio mode
Increase volume
Volume + (E)
Reduce volume
Volume - (F)
Mute function
Mute (A)
Setting the frequency
Seek ▶ (C)
Seek ◀ (D)
Bluetooth® mode
Increase volume
Volume + (E)
Reduce volume
Volume - (F)
Pause / Play function
Mute (A)
Setting the title
Seek ▶ (C) / Select next title
Seek ◀ (D) / Select previous title
5.5 Setting AM/FM mode and frequency se-
lection (Fig. 6)
When you switch on the cordless radio with the
On/Off switch (1), the unit will always be in the
mode last used.
If the unit is in Bluetooth® mode, you will need to
switch it manually to AM/FM mode.
To do so, press the mode button (B) until FM or
AM appears in the display.
Setting the frequency manually
To set the frequency manually, press the "Seek ▶"
(C) button or the "Seek ◀ " (D) button briefl y.
Programming the channels manually
1. To program the channels, switch on the radio
and then press the „Channel" (G) button.
2. The fi rst channel number „1" will appear. Now
use the „Seek ▶" (C) button or the „Seek ◀ "
(D) button to set the channel you want.
- 15 -
30.03.2022 09:43:52 30.03.2022 09:43:52