Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Charging the battery
Connect the charging socket (5) of the LED bar to a suitable USB port using the
supplied USB charging cable or to a mains socket using a mains adapter.
Important: Charging only works with a USB-A to USB-C charging cable. During
the charging process, the charging LED (3) in the motion detector lights up red.
The bar is fully charged as soon as the LED lights up green. After charging is
complete, disconnect the lamp from the charging cable.
Use
• Push the ON/OFF button (1) once to the middle position. The light is turned
on. It burns constantly.
• Push the button (1) again to the last position
(AUTO). The light is switched on and
switches off automatically after 15 seconds
if there is no movement.
Note: Motion detector only turns on the light
when it's dark.
Attaching the magnets
OPERATION
• Place the 3M plastic iron foil (8)
with integrated magnet on the back of
the LED light guide.
8
•
Peel off the 3M tape
and stick the lamp where
you want to install it.
Werbung
