Laser Beam; Led Worklight; Setting The Cutting Angles; Setting The Mitre Angle - Westfalia AZKGS 18 Originalanleitung

Operation
the rear of the saw head and slide the battery pack into the saw so that
the battery pack is locked in position.
To remove the battery pack, press the battery's release button and pull
the battery pack off at the same time.

Laser Beam

Warning! Laser radiation! Observe the safety notes! Laser class 2.
The laser beam is used to show the position of the cut on the work-
piece. It can be turned on or off using the switch (19) on the top of the
saw body.

LED Worklight

To provide additional lighting of the workpiece the saw has a built-in
LED worklight. It can be turned on or off using the switch (21) on the
top of the saw body.

Setting the Cutting Angles

Warning! Before making any adjustments to the settings, check that
the battery has been removed to prevent accidental starting.
After setting the angles always perform test cuts.

Setting the Mitre Angle

The mitre angle is left/right steplessly variable between 0° and 45°. To
set the Mitre Angle loosen the mitre position lock knob (9). Rotate the
table and set the required mitre angle using the scale of the mitre angle
indicator (12). Tighten the mitre position lock knob (9).

Setting the Bevel Angle

The bevel angle is steplessly variable between 0° and 45°. To set the
bevel Angle and loosen the bevel position lock knob (15). Tilt the
cutting head to the desired required bevel angle using the scale of the
bevel angle indicator (14). Tighten the bevel position lock knob (15).
Setting Cutting Depth
The cutting depth can be adjusted if required. To do so, set the sliding
lock piece to the forward position, so the depth of cut adjustment screw
26