RUNZEL RZL-800 Hemma Bedienungsanleitung Seite 12

Memento: When components are used, they must be
cleaned only in the vertical position; under no circum-
stances the components shall be cleaned in horizontal
position.
manual; moreover, we recommend a test run with an
obsolete fabric.
Brush
Set the spray cap with a brush. Hold the tip of the cap
with a brush by hand, combine arrow on the cap with
a single spray line marking on short nozzle body of the
through the cap, align the arrow cap with a double
line markings on a short nozzle. Figure 1. Attach the
spray cap on the appliance. For his removal from a
round brush, roll-intensive counter-clockwise, as shown
in Fig. 2, and align the arrow on the cap with a spray
pointing to the line of the unit. Later, spray cap with a
round brush can be removed.
Spray Nozzles
The tire helps to easily iron the edging and shrink cloth.
Hold the brush tightly and open the tire.
Tightly close the handle around the cloth and iron from
top downward. Before dismounting the brush again,
switch the device off. If no steam is coming from the
brush, it may be removed. Never touch the elements
made of stainless steel, it may lead to burns. Set the
spray cap with a round brush or with a curved spray
nozzle. For direct mounting on a short spray nozzle
wear the cap with a round brush or curved nozzle on
top of the spray nozzle, as shown in Figure 3, the cap
and push forward to lock its position. As short spray
nozzle and cap are placed in six directions, the angle
and direction can be adjusted during the the installation.
with a round brush or a curved tip. The long nozzle
installed in the same manner as the spray nozzle with
a brush. Spray nozzle with round brush or a curved tip
and an elongated spray nozzle can be installed using
the same procedure as for procedure for short nozzles
Install spray cap for doors / windows
4
Runzel RZL-800 Hemma © RLC Grupp 2023 (ENG) Page 12 of 36