Device Description; Control Panel - N'oveen UH550 Betriebsanleitung

● To avoid white coating, you must use the water with hardness of less than 5.4 mEq/l.
● Use of purified or distilled water recommended.
● Do not fill with hot or cold water in the water tank (water temperature should be in the range 19-
30°C).
● Do not tilt or turn humidifier during operation.
● Do not use a humidifier in the vicinity of heaters and other heat sources.
● The minimum distance from the humidifier to the wall should be at least 10 cm, and no less than 1
meter to the ceiling.
● To avoid electric shock, do not add water in the tank while the humidifier is plugged in.
Do not temper or make any changes to the construction of the unit. Do not service the unit by yourself
or by unauthorized personnel, as well as non-compliance with the requirements for the use and
maintenance, as described in this manual. Any of the above will terminate the warranty of this product.

DEVICE DESCRIPTION

1. Mist output
2. Water tank
3. Display
OPERATION
1. Raise the cover
2. Fill the water tank. Note: Do not pour water into the marked area.
3. Place the water tank on the base.
4. Replace the tank cover.
5. Connect the plug to the socket and switch on the device.

CONTROL PANEL

Power on, the device goes into standby after the beep.
ON / OFF button:
the unit is running at first speed.
device is running at the second speed. Press the
show , the device is working at the third speed.
seconds of inactivity.
Timer button:
Press the Timer button, the display will show "00", press the button to increase the value by 1 hour, the
range is 1-12 hours. When the display shows "00", the unit exits the timer setting after 5 seconds of
4. Control panel
5. Base
Press the ON / OFF button, the display shows ,
Press the ON / OFF button again, the display shows , the
ON / OFF button third time, the display will
The display will show the humidity level after 3
8