Product Assembly; Battery Installation - MoMi GLOSSY Handbuch

COMPONENTS:
1. Backrest frame
2. Rear connector tube
3. Right support frame
4. Music box 1O EN
5. M3*13mm Screw
6. Footrest frame
7. Left support frame
8. Seat pad
9. Toy bar and toys

PRODUCT ASSEMBLY:

1. Check the all parts with above list before assembly.
2. Place the left and right support frames opposite each other, with the rear connector tube between
them on a flat surface(1).
3. Lift the flip clip on the both side of the rear connector tube, fit the leftsupport frame & rightsupport
frame into the rear frame tube. Close the flip clip over the tube and push down until the flip clip locks in
place(2,3).
4. Fit both ends of the footrest frame together and screw down(4,5).
5. Fit both ends of the backrest frame together by holding down the spring loaded pin and push the
frames till the pin locates into the holes(6).
6. Open the pocket at the rear of the seat cover back and slide over the seat backrest,stretch the bottom
of the seat cover over the footrest frame (7).
7. Slide the top of the music box through the hole in the seat cover and onto the footrest frame. Reverse
the procedure above to remove the music box, attached the clips under the seat(8,9).(Notice the
orientation of the music box)
8. Clip the toy bar to each side of the bouncer franne (10). Pull the clip off to remove the toy bar.
ADJUSTABLE SEAT RESTRAIN:
Place baby in the bouncer with the seat restraint positioned between his legs. Fasten the buckles on both
sides of the restraint, pressing until you hear a "click". Make sure the seat restraint issecure by pulling it
away from your baby's body. It should remain fastened. Always use restraint system.

BATTERY INSTALLATION:

Use a small Philips-head screwdriver to open the battery compartment door on the music/vibration box.
Insert the battery as indicated inside the battery door and reattached the battery compartment door with
EN 7