Technical Specifications - Vigrue F50/9040 Bedienungsanleitung

Technical Specifications:

Nail/Brad Capacity: 18 Gauge 10-50mm
Fastener Diameter: 1.05x1.26 mm
Stapler Capacity: 5.7mm crown Series 90 Up to 40mm length
(Fasteners are available from local hardware stores)
Working Pressure: 60-100 PSI
Av. Air Requirement: 3CFM / 85Lt / min
Air Inlet:
Safety:
●When using compressed air always follow the safety codes of
practice laid out by the compressor manufacturer.
●Damaged or split air hoses can cause a 'whip' hazard.
Immediately replace damaged air hoses.
●Ensure all air couplings are secure and tight.
●Do not try to modify the tool to accept fasteners other than
those specified.
●Only use this equipment for its intended use. Do not modify or
change its design.
●When tool is not in use always disconnect from the air supply.
●Maintenance should only be carried out by a competent
person.
Page 1