How To Fill The Water Tank - JBM 54125 Bedienungsanleitung

ASSEMBLY INSTRUCTION
FAN ASSEMBLY
1. Align the two supporting tubes into the holes of the
base, then fix in place from the bottom using the
screws provided.
2. Loose the two bolts located at the back of the unit
(do not fully unscrew the two nuts or they will fall off).
Fix the motor unit to the tubes and retighten the nuts.
3. Install the rear grid, plastic nut, blades, and blade
spinner to the motor shaft and fix in place.
4. Install the front grid and net frame, and secure using
the screw on the net frame. Inset the upper flexible
hose on the motor unit into the mist vent that is lo-
cated at the front of the fan grid (ensure the hose is
free of kinks).
WATER TANK ASSEMBLY
1. Place the misting generator on to the base, ensuring
it is appropriately seated in the recess.
2. Place the water tank on top of the misting generator.
Fit the cover to the top of the water tank.
3. Insert the lower flexible hose on the motor unit into
the water tank cover (ensure the hose is free of kinks)

HOW TO FILL THE WATER TANK

1. Unplug the appliance before filling and cleaning the
water tank.
2. Remover the water tank and turn it upside down.
3. Twist the cap anticlockwise to unlock it.
4. Fill the tank with cold and clean water, making sure
not to overfill it. Do not add any chemicals, oils, or
other additives. Only use cold or warm water in the
water tank. The water must not be above 40.
5. Refit the cap and turn it clockwise to lock it in place.
6. Turn the tank over and place it back on the misting
generator.
OPERATION INSTRUCTIONS
Indicator Lights
1. Mode:Normal/Natural/Sleeping
2. Timer indicator:0.5h/1h/2h/4h
3. Speed: High-Medium-Low
4. Power indicator
5. Swing indicator
6. Mist indicator:
7. Max.-Medium-Min
A: MIST BUTTON
1. Press the "Mist" button to switch the ultrasonic mist
and off. Adjust the mist volume (Max-medium-mini-
mum) by pressing the "Mist" button several times.
2. When the mist function is selected, the water tank
indicator light will be illuminated green.
3. If the water tank is empty (or short of water), the wa-
ter indicator light will be illuminated red.
4. The mist function and fan function can be worked in-
dependently or together.
B: TIMER BUTTON
Press the "Timer" button when the fan is on. The indicator
will show the time remaining until the fan is due to switch
off. You can select the length of time the fan will be in ope-
ration from spans ranging from 0.5 to 7.5 hours in 0.5-hour
increments. Press the TIMER button repeatedly, and the
sum of the values of the lights is the remaining time until
shut down.
· 6 ·
REF. 54125