Beurer LV 50 Fresh Breeze Gebrauchsanweisung Seite 21

3. Place the PET bottle onto the bottle holder of the table fan as shown.
After installing the PET bottle, wait approx. 3-4 minutes before
turning on the table fan, so that the evaporation filter can absorb
enough water.
Even when the water tank is empty, the evaporation filter
remains damp for some time and continues to cool. The
table fan can also be operated without the PET bottle and
water supply. In this instance, the table fan functions like a
fan without the evaporation principle.
4. Connect the micro USB cable provided to a USB mains adapter
(output: max. 5 V DC / 0.5 A, not included in delivery).
5. Insert the micro USB cable into the micro USB port on the rear of the
table fan. Then plug the USB mains adapter (USB mains adapter not
included in delivery) into a suitable wall socket. Arrange the micro
USB cable such that it does not pose a trip hazard.
Alternatively, you can also operate the table fan using your com-
puter. To do this, connect the table fan to the computer via the
USB port. Make sure that the output values of the USB socket
comply with information on the rating plate.
6. Press the ON/OFF button to switch on the table fan.
A blue indicator light below "ON/OFF" will light up.
7. The table fan has three speeds.
Use the FAN button to select your desired speed.
1 = low speed
2 = medium speed
3 = high speed
8. Press the ON/OFF button to switch the table fan off again.
The blue indicator light below "ON/OFF" will disappear.
If you do not intend to use the table fan for an extended period of time, unplug the mains adapter
from the wall socket/unplug the micro USB cable from the computer.
9. After each use, remove the residual water from the water basin, so that no water can escape in
the event of accidental impacts. To remove the residual water from the water basin, proceed as
follows:
• Make sure that the table fan is unplugged.
• Pull the PET bottle and bottle adapter straight up and off.
• Press the front and rear housing release latches.
• Carefully lift the housing straight up and off
• Empty any residual water from the water basin into the sink.
• Allow all parts of the table fan to dry completely.
• Change the drinking water in the PET bottle daily.
21