Polar CC611 Bedienungsanleitung Seite 4

EN
Installation
Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water then dry well.
Operation
Control Panel
The control panel is located below the doors on the
rear of the appliance.
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Press the button to turn the light On or Off
as required.
Setting the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the or buttons to display the
required temperature.
3. Press the SET button to store the temperature.
4
CC611-CC666_ML_A5_v9_20230510.indb 4 CC611-CC666_ML_A5_v9_20230510.indb 4
Manual Defrost:
Press and hold the button for 6 seconds to begin
automatic defrost. The defrost light illuminates.
The defrost cycle will end automatically.
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
• Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
• Do not place uncovered hot food or liquids (like
acidic fluids) inside the appliance (as it can
damage the evaporator).
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods
of time.
Cleaning, Care &
Maintenance
Switch off and disconnect from the power
•
supply before cleaning.
• The doors can be removed for ease of
cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a
heat source will also increase the amount
of ice and internal/external condensation.
If external condensation occurs wipe the
surface down with a cloth.
Excessive ice will result in longer running
times that will increase energy consumption
and increase the deterioration of
components.
2023/5/10 09:46 2023/5/10 09:46