Terms Of Warranty; General Installation Instructions - Ground Zero URANIUM Serie Bedienungsanleitung

Thank you for choosing a GROUND ZERO product and welcome to your new URANIUM series amplifier! This
is the owner´s manual providing instructions on the operation & installation of this amplifier. Please, read it
carefully. If you have any further questions, please contact your local GROUND ZERO dealer or our regional
distribution partner at your country. Amplifiers are one of the most important parts of your car audio system.
However, they won´t deliver its full performance, unless each part of the whole system is tuned carefully
matching each other. Therefore, we recommend consulting a car audio specialist to compile the desired sound
system, as well as for installation and individual, correct sound tuning.
We hope you will enjoy the sound quality of one more enthusiastic development by the
Products belonging to the GROUND ZERO URANIUM series stand for high-end sound quality or extreme power
handling capability. Each product of the URANIUM series has been developed carefully to fulfill the demands
of music enthusiasts with high audiophile expectations at a reasonable price level. Applying GROUND ZERO´s
experience from sound quality competitions at tuning the product details carefully, results in emotional and
amazing audio reproduction. These distinguished products point out the main purpose by their designation: SQ
beyond the average.
The limited warranty for this product is covered by GROUND ZERO´s regional distribution partners and their
terms and conditions. For further information contact your local retailer or regional distributor.
• As a precaution, it is recommended to disconnect the vehicles battery before mounting the amplifier.
Note: For new vehicles, disconnecting the battery might cause various errors in your vehicle´s electric
system that can be cleared only by authorized service partners of your vehicle´s manufacturer! Please ask
your service partner first before disconnecting the battery!
• The power supply wire (+12 V) has to be protected within max. 20 cm / 8" by a main fuse holder with a
fuse value matching the recommendation for your amplifier
Note: If there is more than one amplifier connected using this power wire, the main fuse value must be
equal to the sum of the recommended fuses of all connected devices. However, make sure the diameter
of your power wire will be enough for the required current!
• If necessary, replace a defective fuse by a fuse with identical quality and value
• Never drill holes to the vehicle´s gas tank, brake lines, to wirings or any other important vehicle parts!
• Never pass wires over sharp edges or vehicle parts due avoid any kind of damage
• Keep the wiring away from the antenna and electronic devices contributing to radio reception
• Lay the power supply wiring always separated from speaker wiring to avoid disturbance
• The amplifier contains a temperature protection circuit that turns the device off in case of overheating. After
a certain cooling time, it will turn on automatically. To avoid heat build-up, enough air supply for cooling
must be provided. Never cover the surface of the amplifier´s heatsink entirely
• The amplifier should NEVER be mounted onto a vibrating part or surface such as a subwoofer enclosure.
This might lead to malfunction due to loosened electrical parts inside the amplifier
Some amplifiers offer a high-level input option, however if a pre-amplified output (RCA) is available (at the
•
head unit), it is strongly recommended to make use of them
URANIUM SERIES
GROUND ZERO GZUA SQ AMPLIFIER
Introduction
GROUND ZERO engineering team!
URANIUM Series – Amazing Sound Quality

Terms of Warranty

General installation instructions