Operation; Cleaning And Care; Maintenance - Seto FC LED RECHARGEABLE Serie Gebrauchsanleitung

Loading
WARNING!
Loading must only be carried out in dry rooms.
"Low Battery Message System"
Early detection of low battery capacity by "Low Battery Message System" (LBMS). The torch starts flashing at one-minute
intervals when the remaining capacity is low. From this point on, the light should be recharged.
To charge the battery safely, follow the sequence below:
1. Open the protective cap of the charging socket by turning it anticlockwise.
2. Plug the USB-C charging cable with the USB-C side into the charging port of
the luminaire.
3. Connect the USB part of the charging cable to your charger.
4. After charging (indicator LED lights up green), disconnect the charger from
the mains, disconnect the luminaire and close the charging socket with the
protective cap.
ATTENTION!
• Danger of glare! Do not shine in anyone's eyes and do not look directly into the light. This can lead to temporary
or even permanent eye damage (risk of retinal injury).
• Do not use product for eye examinations (pupil test). Increased risk of glare.
• Keep the luminaire away from children.
• The outer casing of the luminaire may become warm during intensive use. This is normal.
• Do not use the luminaire near high temperatures such as fire or heaters. This may cause an explosion or ignition.
• Do not use if the operating temperature range (-10 to +40 °C) is exceeded or undershot.
• The rechargeable battery may only be used with a suitable charger.
Do not use any solvents, alcohol or other chemicals to clean the plastic parts / metal parts.
To remove dirt, dust, oil and grease, etc., use a soft, dry, lint-free cloth.
The SETO FLASHLIGHT FC LED RECHARGEABLE luminaire was designed to be maintenance-free. Therefore no main-
tenance work is necessary.
10

Operation

Cleaning and care

Maintenance