Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
9.1.e - Using the machine (Fig. 14)
-
After having started the machine and se-
lected the type of cycle, start the cleaning
operation by pressing the levers (4) and
holding them pressed to start rotation of
the brush and the dispensing of water,
then push the machine by means of the
handles (54) in the handle bar (1).
N.B.:
Releasing the levers (4) stops the rotation of
the brush and the dispensing of water.
N.B.:
To avoid damaging the floor, do not use the
machine in a fixed position with brush rota-
tion activated
N.B.:
The correct way of cleaning and drying the
floor is to move the machine forwards. Mov-
ing the machine backwards damages the
blades as well as not allowing correct aspira-
tion of the water present on the floor.
-
If necessary, adjust the quantity of wash-
ing water using the tap (55).
-
Check the status of the battery charge by
the indicator (24) (only on version BC).
9.1.f - End of use and switching off
(Fig. 1)
-
At the end of the cleaning operation and
before turning off the machine, stop the
dispensing of water and the rotation of
the brush by releasing levers (4) and
pressing the button (27) to continue with
the aspirator to remove all of the liquid
present on the floor, and then turn off the
aspirator by pressing button (25).
-
Lift the floor wiper (14) by pressing the
pedal (3) to the end stop, engaging it in
its slot.
WARNING:
Always lift up the squeegee at the end of
cleaning in order to prevent the deforma-
tion of the rubber blades.
-
Press the button (26) turning it off.
-
Disconnect the electric power cable from
the socket (for E version only).
9.1.g - Warnings while using the ma-
chine (Fig. 1)
-
While using the machine, the occurrence
of the following errors is signalled by the
coming on of the leds.
Suction unit outlet overcurrent error
Led (A) is flashing and Led (B) is con-
stantly lit.
Brush unit outlet overcurrent error
Led (A) is flashing and Led (C) is con-
stantly lit.
Suction unit outlet open circuit error
Led (A) is flashing and Led (D) is con-
stantly lit.
Brush unit outlet open circuit error
Led (A) is flashing and Led (E) is con-
stantly lit.
NOTE:
When any of the above mentioned error sig-
nals is displayed, it is necessary to turn off
the machine and then turn it on again, in or-
der to set it back to normal functioning.
ENGLISH - 9
Werbung
Inhaltsverzeichnis
