IBEA IB-G3500 Benutzerhandbuch Seite 45

6.2. USING ELECTRIC APPLIANCES:
WARNING:
Make sure that the appliance is switched OFF before connecting it to the generator.
Do not move the generator while it is running.
ENGINE SWITCH
CONTROL PANEL
IB-G3500
6.2.1. AC APPLICATION:
6.2.2. Check the volt meter for su cient voltage.
6.2.3. This generator is properly tested and adjusted and
set at the factory.
6.2.4. If the generator does not produce the speci ed
voltage please contact your local dealer.
6.2.5. Turn o the switch(es) of the electrical appliance(s)
before connecting to the generator.
6.2.6. Insert the plug(s) of the electrical appliance(s) into
the receptacle/socket.
6.2.7. Check the amperage of the receptacles/sockets used
making reference to the TABLE and be careful not to take a
current exceeding the speci ed amperage.
6.2.8. Check that the total wattage of all appliances that is
being connected to the generator does not exceed the
rated output of the generator.
6.2.9. Turn on the appliance switch.
NOTE: If the circuit breaker "TRIPS" during operation the generator is overloaded or the
appliance is defective. Stop the generator immediately and check the appliance and /or
generator for overloading.
DIGITAL
METER
12V OUTPUT
CIRCUIT
AC SOCKET
BREAKERS
GROUND TERMINAL
ON
OFF