USX-MOUNT XMM006-2-03 Bedienungsanleitung Seite 11

3. Drill pilot holes using a 5/32 in. (4.0 mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of 2.9 in. (74 mm). Be sure to drill into the center
!
of the studs.
4. Install wall plate using three lag bolts . Tighten the lag bolts only until they are pulled firmly
05 01
against the wall plate.
CAUTION: Improper use could reduce the holding power of the lag bolt.
!
DO NOT over-tighten the lag bolts.
Go to STEP 3 on PAGE 14
2.9"(74mm)
No!
5/32"
Level
(4.0mm)
05
Wall plate
01
11