Peripheral Unit Controller (Puc) Setup; Factory Reset; More Technical Questions - Bang & Olufsen BEOSOUND THEATRE Bedienungsanleitung

B E O S O U N D T H E A T R E
P E R I P H E R A L U N I T C O N T R O L L E R ( P U C ) S E T U P
A Peripheral Unit Controller, or PUC, is a cable for products that use infrared (IR)
transmitters. PUC cables allow the Beosound Theatre to act as an infrared remote
control for products that require it, such as TV boxes. Products connected to your
Beosound Theatre with a PUC cable can still be operated with a third-party remote.
Follow the instructions in the app to set up your Bang & Olufsen remote, PUC, and
external device(s). With a PUC cable, your Beosound Theatre can control up to 2
external devices.
PUC cables can be purchased from your Bang & Olufsen dealer.
F A C T O R Y R E S E T
You can restore factory settings by pressing and holding the next and previous
buttons at the same time for 8 seconds. You'll find them on the top control panel.
Your Beosound Theatre will begin the reset process and, after approximately one
minute, it will be ready for first-time setup again.
M O R E T E C H N I C A L Q U E S T I O N S ?
For further support, please visit:
22