DJI DL Handbuch Seite 6

DJI DL/DL-S LENS User Guide
Using the Lens
Filters
DJI offers the DL/DL-S lens protector and filters
specifications of the DL/DL-S lens protector and filters are shown below.
Filter/Protector
DJI DL/DL-S ND4 Filter
DJI DL/DL-S ND8 Filter
DJI DL/DL-S ND16 Filter
DJI DL/DL-S ND32 Filter
DJI DL/DL-S ND64 Filter
DJI DL/DL-S ND128 Filter
DJI DL/DL-S Lens Protector
* DJI DL 18mm F2.8 ASPH Lens only supports filters with a diameter of 55 mm. Purchase third-party
filters separately.
For optimal performance when shooting, the following combinations are recommended when
mounting the lens onto the gimbal camera:
a. Lens hood + lens protector
b. Lens hood + balancing ring
c. Lens hood + ND filter
d. Two ND filters
The total weight of each combination mentioned above should be between 10 to 35 g. It is
recommended to keep the total weight of the attached components around 20 g when the
gimbal is balancing to ensure optimal video recording performance.
• The gimbal performance is affected by the weight of the camera. Refer to the
requirements above to mount the lens protector, filter, and lens hood when using the
DL/DL-S lens.
• Third-party filters are supported for both DL/DL-S lenses. Make sure to use a filter with
a thickness of 4.4 mm and a total weight of 35 g (including the hood).
• The lens protector is only used to protect the lens during transportation, storage,
and use. It is recommended to use the protector in severe shooting environments to
prolong the service life of the lens. Be aware that there might be lens glare in some
situations when the protector is in use.
4
©
2023 DJI All Rights Reserved.
*
, which are available on the DJI online store. The
Diameter
46 mm
46 mm
46 mm
46 mm
46 mm
46 mm
46 mm
Weight
Approx. 9 g
Approx. 9 g
Approx. 9 g
Approx. 9 g
Approx. 9 g
Approx. 9 g
Approx. 9 g