Health And Safety; General Safety Instructions - Avalla X-95 Anleitung

Health and safety

General safety instructions

Symbols from the unit
This unit uses
a flammable
refrigerant.
If the refrigerant leaks
and encounters fire
or heat, it may create
harmful gas and there
is risk of fire.
Warning: Do not operate near combustible or explosive materials, heat sources, or
any objects that may block air inlet and outlet. Keep the air inlet and outlet free of
obstacles. Only use in rooms that exceed 4m² in size.
Warning: Do not touch the air inlet or the evaporator surface, located behind the
filter. Doing so could cause injury. Always ensure the filter is completely dry before
reinstalling into the unit.
The following must always be observed for safety
•
This appliance is not intended to be used by children. Persons with lack of
experience or knowledge, reduced physical, sensory, or mental capabilities,
can use this appliance if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
•
involved.
The unit is designed only for use with R-290 propane gas. The refrigerant loop
•
is sealed, only qualified technicians should perform servicing.
•
Never discharge the refrigerant into the atmosphere.
R-290 propane gas is flammable and heavier than air, it collects first in low
•
areas, it can be circulated or dispersed by fans.
If propane gas is present or even suspected, do not allow untrained personnel
to attempt to find the cause. R-290 has no odour, the lack of gas smell does
not indicate a lack of escaped gas. Do not allow to get in eyes, on skin, or on
•
clothing. Do not breathe the vapours or gas.
• If a leak is detected, immediately evacuate all persons from the area, ventilate
and contact the local fire department to advise them that a propane leak has
occurred. Do not let any persons back into the area until the qualified service
•
technician has advised that it is safe to return.
•
Component parts must only be replaced with identical repair parts.
Any person working on, or breaking into a refrigerant circuit, should hold a
current valid certificate from an industry-accredited assessment authority,
which authorises their competence to handle refrigerants safely in accordance
•
with an industry, recognised assessment specification.
If the supply cord is damaged, it must be replaced by the manufacturer, its
•
service agent, or similarly qualified persons.
The appliance must be disconnected from its power source during servicing,
cleaning or when not in use. Do not use chemicals to clean the appliance.
09
Class I Read the user manual
Construction
(Earthed)
carefully before
operation.
Service personnel are
required to carefully
read the user manual.
En