Herunterladen Diese Seite drucken

JONSBO CR-3000 Bedienungsanleitung Seite 2

Werbung

Remove the AMD mounting bracket and keep its original backplane
Entfernen Sie die AMD Montagehalterung und behalten Sie
die ursprüngliche Backplane
Retirez le support de fixation AMD et conservez sa plaque arrière d'origine
AMD 장착 브래킷을 제거하고 기본 후면 패널 유지
卸下AMD固定支架,保留其原装背板
Remove copper bottom protective film
Schutzfolie des Kupferbodens entfernen
Enlever le film de protection de fond en cuivre
구리 바닥 보호막 제거
去除铜底保护膜
Installing the backplane
Installation der Backplane
Installation du panneau arrière
후면 패널 설치
安装背板
Remove the fan before installing the heat sink
Entfernen Sie den Lüfter vor dem Einbau des Kühlkorpers
Retirez le ventilateur avant d'installer le radiateur
히트싱크를 설치하기 전에 팬을 분리하십시오
安装散热器前,请卸下风扇
Place the heat sink on the CPU and fix it on the installation fastener
Setzen Sie den Kühlkurper auf die CPU und befestigen Sie
ihn am Installationsbefestiger
Placez le radiateur sur le CPU et fixez - le au fermoir de montage
CPU에 히트싱크를 놓고 장착 탭에 고정
将散热器放在CPU上,并固定到安装扣具上
AMD Befestigung installieren
AMD Befestigung installieren
Installation des fixations AMD
AMD 버클 설치
安装AMD扣具
Connect the fan lead to the main board according to the figure above
Verbinden Sie das Lüfterkabel entsprechend der Abbildung
oben mit der Hauptplatine
Connectez le fil du ventilateur à la carte mère selon l'image ci - dessus
위 그림에서 팬 컨덕터를 마더보드에 연결
依上图将风扇导线与主板连接
Rendering of installation completion
Darstellung der Fertigstellung der Installation
Diagramme de fin d'installation
설치 완료 효과도
安装完成效果图
Apply heat conduction paste on the CPU
Warmeleitpaste auf die CPU auftragen
Appliquer une pate conductrice de chaleur sur le CPU
CPU에 열전도제를 바르다
在CPU上涂导热膏
3

Werbung

loading