Chacon 54420 Bedienungsanleitung Seite 4

- If the alarm is triggered, the selected alarm melody
sounds.
- Press any button to stop the alarm. Otherwise, it will
stop automatically after 1 minute.
Note
- When the alarm function is activated, the alarm
melody sounds daily at the selected time.
- To completely deactivate the alarm function, enter
alarm mode (ALARM) and press the SET button (4)
repeatedly until the display does not show an alarm
time (-:--).
Now the display does not show ALARM any more.
Note-Snooze function:
- In normal mode, press the UP button (5) to activate
or deactivate the snooze function. When the snooze
function is activated, is shown in the display.
- The snooze function can only be activated when the
alarm function is active.
- With the snooze mode enabled, press any button
while the alarm is sounding to interrupt the alarm for a
limited time. The alarm melody sounds multiple times
for one minute each.
f. Timer function
- Press the MODE button (2) four times in normal time
mode to go to the timer function settings.
- Press the SET button (4).The hours display begins
to flash.
- Press the DOWN button (5) or the UP button(6) to
select the hour and confirm your selection by pressing
the SET button(4).The minutes display begins to flash.
- Repeat the process to set the minutes.
- After the selection has been made and confirmed by
pressing the SET button (4), the count-down timer is
activated.
- Once the count-down finishes, the alarm signal goes
off for one minute.
You can press the ALARM button (3) to turn off the
alarm signal.