Pedalo 653130 Anleitung Seite 2

User manual
653130
Pedalo® Balance Board 150
Please read instruction completely and keep it.
Important information and warning hints:
Warning!
The device is to be used with caution, since it requires great skill, so as to avoid falls or collisions causing injury to the user
or third parties. In case of doubt first use the device only with assistance and/or appropriate protective equipment.
Warning!
The packing is not part of the product and have to be disposed.
Warning!
The device is only to be used for the purposes described in this user manual.
Even if this device is also play-equipment for children, the assembling should be carried out or supervised always by an adult.
Warning!
Only use device on level ground with even and firm surfaces.
On sensible grounds use an anti-slip mat under it if necessary.
After longer or frequent use, check that the screws are tight and retighten if necessary.
Defective and worn parts should be replaced by original replacement parts immediately.
The product is made of natural birch or beech wood. Differences in color, structure, grain, small included knots or scars, prove the
genuineness of the material and therefore show no reduction in quality.
Maintenance and cleaning:
Can be wiped off with a damp cloth. Do not use any solvent-based, acidic or abrasive detergents.
Protect item from damp and wet.
!!!! Do not jump onto the appliance and never use it as a skid board!!!!
This device is meant for using from persons at the age of 3 up.
Maximum weight capacity: 200 kg - skids lengthwise to the board and 100 kg - skids across the board.
Assembly runners:
The runners can be individually mounted longitudinally or transversely. This results in different applications for seesaw and rocking movements.
Please note that both skids are always fastened the same way. Otherwise, the board seesawed at an angle! Each runner is fastened to the hole
row of the board with 4 flat-head screws (M6 x 5 cm) and cross-hole nut bolts.
Assembly rubber stoppers:
At each corner hole of the board a rubber stopper is screwed on. From the top of the board, a sleeve
nut is inserted into the hole. From below, the rubber stopper is screwed on. If the runners are mounted
on the narrow side, the rubber stoppers are eliminated.
Accessory:
Pedalo-Suppoert Bars 'Telescopic'
653130
Height is adjustable
Copyright ® Holz-Hoerz
Holz - Hoerz
Münsingen
Seite 2 von 2
Holz-Hoerz GmbH
Dottinger Str. 71
D-72525 Münsingen
Tel. +49 (0) 7381 - 9357 0
Fax +49 (0) 07381 - 9357 40
72525
info@pedalo.de
www.pedalo.de
Stand: 24.5.2016 He/ 02.10.2018 SW