LINDSTROM RX-Serie Biospring Bedienung Und Pflege

RX Series Biospring
Instructions & Care
Lindstrom's RX Series pliers and cutters use
a unique Biospring . The Biospring
®
tension throughout the working cycle of the tool
and can be adjusted in three different positions.
Inserting/Installing the Biospring
1. Place the slotted wider end of the Biospring
near the receiver slot.
2. Simultaneously push the wide end of spring
into receiver slot (arrow 1) and rotate thin knob
end up (arrow 2).
3. The spring will make an audible sound when
the wide end seats correctly. If you don't hear the
"CLICK" it is not seated all the way and will fall
out with use.
®
4. Then simply
insert small knob
end of the spring
into the other
handle at your
reduces
®
desired setting.
5. Using the
adjustment port
® closest to the
joint will provide
a lighter tension
®
and the position
furthest from the
joint provides the
greatest tension.
Care for the Biospring
If you are storing the RX Series pliers or cutters
in a case, with the protective cap installed, or
in any way where the tool is held in the closed
position, you MUST disconnect the knob end of
the Biospring
will deform the Biospring
will not stay in the adjustment port.
New Biospring
a deformed spring (2) which was
removed from a pair of pliers
that was stored with the handles
forced closed and the spring still
engaged at both ends.
®
from the handle. Failing to do so
®
. A deformed Biospring
®
(1) compared to
®
®