Werbung
DE
f)
Geräte von Feuer – und Wärmequellen fernhalten.
g)
Das Gerät darf nicht in Plätzen, wo große
Temperaturschwankungen
herrschen,
die
Beschädigung führen können, installiert werden.
ACHTUNG!
Obwohl
das
Gerät
in
Hinblick
auf
Sicherheit
entworfen
wurde
und
über
Schutzmechanismen
sowie
zusätzlicher
Sicherheitselemente
verfügt,
besteht
der
Bedienung
eine
geringe
Unfall-
oder
Verletzungsgefahr. Es wird empfohlen, bei der
Nutzung Vorsicht und Vernunft walten zu lassen.
4
zu
bei
U S E R M A N U A L
LEGEND
The product satisfies the relevant safety
standards.
Read instructions before use.
The product must be recycled.
WARNING! or CAUTION! or REMEMBER!
Applicable to the given situation (general
warning sign).
Electric shock warning.
Only use inside.
USAGE SAFETY
ATTENTION! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in an electric shock, fire and/
or serious injury or even death.
The terms „device" or „product" are used in the warnings
and instructions to refer to ADVERTISING LED DISPLAY.
ELECTRICAL SAFETY
a)
The plug must fit the socket. Do not modify the
plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b)
Do not touch the device with wet or damp hands.
c)
Use the cable only for its designated use. Never use
it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil,
sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
d)
If working with the device outdoors, make sure to
use an extension cord suitable for outdoor use.
Using an extension cord suitable for outdoor use
reduces the risk of electric shock.
e)
If using the device in a damp environment cannot
be avoided, a residual current device (RCD) should
be applied. The use of an RCD reduces the risk of
electric shock.
f)
Do not use the device if the power cord is damaged
or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or
the manufacturer's service centre.
g)
To avoid electric shock, do not immerse the cord,
plug or device in water or other liquids. Do not use
the device on wet surfaces.
h)
Do not use in very humid environments or in the
direct vicinity of water tanks.
i)
Prevent the device from getting wet. Risk of electric
shock!
SAFETY AT THE WORKPLACE
a)
If you discover damage or irregular operation,
immediately switch the device off and report it to a
supervisor without delay.
b)
If there are any doubts as to the correct operation
of the device, contact the manufacturer's support
service.
c)
Only the manufacturer's service point may repair the
device. Do not attempt any repairs independently!
d)
In case of fire, use a powder or carbon dioxide
(CO
) fire extinguisher (one intended for use on live
2
electrical devices) to put it out.
e)
Please keep this manual available for future
reference. If this device is passed on to a third party,
the manual must be passed on with it.
EN
f)
Keep packaging elements and small assembly parts
in a place not available to children.
g)
Keep the device away from children and animals.
PERSONAL SAFETY
a)
Do not use the device when tired, ill or under the
influence of alcohol, narcotics or medication which
can significantly impair the ability to operate the
device.
b)
The device is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience
and/or knowledge unless they are supervised by
a person responsible for their safety or they have
received instruction on how to operate the device.
c)
The device can be handled only by physically fit
persons who are capable of handling it, properly
trained, familiar with this manual and trained within
the scope of occupational health and safety.
d)
The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
SAFE DEVICE USE
a)
Disconnect the device from the power supply
before commencement of adjustment, cleaning and
maintenance. Such a preventive measure reduces
the risk of accidental activation.
b)
Device repair or maintenance should be carried out
by qualified persons, only using original spare parts.
This will ensure safe use.
c)
To ensure the operational integrity of the device, do
not remove factory-fitted guards and do not loosen
any screws.
d)
Clean the device regularly to prevent stubborn grime
from accumulating.
e)
It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.
f)
Keep the device away from sources of fire and heat.
g)
Do not install or use the device in locations where
there are large temperature fluctuations that could
cause rupture and damage to the device.
ATTENTION! Despite the safe design of the device
and its protective features, and despite the use of
additional elements protecting the operator, there
is still a slight risk of accident or injury when using
the device. Stay alert and use common sense when
using the device.
5
Werbung
