Navitel NS1000 Bedienungsanleitung Seite 23

Charging electronic devices
• To charge an electronic device from a portable power station, activate the needed output port by pressing buttons A, D or E and connect the
corresponding cable or adapter to this port.
• When a port is activated, the corresponding button on the portable station is lit up green and the display is enabled to show the status of the
corresponding port. When the port is disabled, the button and the display are turned off.
• If there are no devices connected to the output ports within 20 seconds, the portable charging station will enter standby mode. To exit standby
mode, connect an electronic device to the station.
• After charging is completed, turn off the output ports by pressing the corresponding buttons.
• An advanced battery management system allows you to charge a connected device through the DC output ports and USB output ports while
the portable power station is charging.
Do not connect electronic devices to the ac output while the power station is charging!
Portable power station overload
When power station is overloaded:
• AC output will automatically turn off;
error code indicator will show code W04;
•
• DC outputs power indicator will remain lit if those ports are activated.
NAVITEL NS1000 | 23
EN