Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
2
3
4
5
6
Station
Direction button
Increase speed
1
2
3
Display with speed display (x 1.000)
Handpiece connection point
6
7
Bit Dummy
Protective cap
Twist lock
9
10
11
Fig. 1
Fig. 2
Protective cap
BIT CHANGE
1.
Hold the handpiece in your hand (Fig.1), turn the twist lock counterclockwise
(left) to open the collet, and remove the bit.
2.
Insert the new bit and turn the twist lock clockwise (to the right), check the
tightness of the bit again before operation.
HANDPIECE CLEANING
- Clean the spindle daily of filing dust. Make sure that the collet is closed.
- To do this, unscrew the protective cap
- Remove the dust from the spindle and from inside the protective cap with a
medium or hard brush.
- Failure to heed this notice may cause long-term damage to the device and you
will lose your warranty!
SHUTTING DOWN
If you are not going to use the device for a long time, disconnect it from the mains by
pulling the mains plug out of the socket.
TROUBLESHOOTING
PROBLEM
CAUSE
The handpiece cable is not
firmly connected to the station.
Motor does not run
Handpiece cable is defective
or porous
Handpiece stops suddenly
Motor in the handpiece is
(safety protection system)
overloaded or the bit is blocked
during work
7
On/Off - Start/Pause
Decrease speed
5
4
Connection cable
8
Handpiece
Handpiece connection
12
13
Fig. 3
Turning spindle
Protective cap
(Fig.2)
and remove the spindle (Fig.3).
SOLUTION
Check that the plug is correctly
seated on the station
Handpiece cable
Check the rotary lock that the
collet is closed. Cleaning the
collet and protective cap.
LED-ERROR CODE
DESCRIPTION
„E1" means Over Voltage Protection. The collet on the handpiece
Code E1
may be open or the handpiece is blocked due to excessive pressure
or dirt.
Pause mode,
Status light orange
work mode
SAFETY INSTRUCTIONS
- Set the speed to 0 before connecting or disconnecting
- Place the device on a firm, level surface before using it
- If possible, wear safety goggles and a dust mask
- Make sure that nothing can get caught in the rotating attachment while working
(such as long, loose hair or shirt sleeves).
- Switch off the device when you put the handpiece down.
- Do not operate the device in the immediate vicinity of water (e.g. in the bathtub)!
- Avoid knocks, bumps or vibrations on the device.
- Only use handpieces intended for this device.
- Do not use defective handpieces or bits.
- Observe the information on the maximum speed of your grinding attachments.
- Insert the grinding attachments fully into the chuck.
- Never open the quick release while the device is in operation.
- Disconnect the device from the mains when not in use for a long period of time.
- Disconnect the device from the mains by pulling the plug out of the socket.
Never pull on the cable.
DISPOSITION
Power tools, accessories and packaging are to be recycled in an environmentally
friendly manner.
ONLY FOR EU COUNTRIES
Do not dispose of power tools in household waste! According to the
European Directive 2002/96/EC on waste electrical and electronic
equipment (WEEE) and its implementation in national law, power tools
that are no longer usable must be collected separately and recycled in
an environmentally friendly manner.
Within the EU, this symbol indicates that this product must not be disposed of with
other household waste. Old devices contain valuable recyclable materials, which
should be recycled and in order not to harm the environment or human health
through uncontrolled waste disposal. Therefore, please dispose of old devices via
suitable collection systems.
set speed and
press again to switch to
Werbung
