Hyundai Men Pro Corded Hair Clipper & Trimmer Bedienungsanleitung Seite 4

INSTRUCTIONS FOR HAIR CUTTING
1. Inspect the clipper, making sure that it is free of oil between the cutting blade teeth and turn
the uniton to distribute the oil and to make sure it is running smoothly. Wipe off any excess oil.
This should be done after each use. While using the unit, untwist the cord form time to time to
avoid tangling.
2. Seat the person so their head is approximately at your eye level. This allows ease of visibility
while cutting and a relaxed control of the unit.
3. Before cutting always first comb the hair so it is tangle free and as it is naturally worn.
4. Place a towel around the neckand shoulders of the person having the haircut.
REMINDERS
• Cut the hair in a relaxed and slow mannerUse short strokes only to work gradually over the
entire head
• Always take off a little hair at a time, you can always trim off additional hair later.
• As you work, comb the hair frequently back into the style to which you are cutting.
• When cutting with this hair clipper it is better to leave the hair dry, not wet. With the hair dry it
is much easier to control the amount of hair being cut.
BEGINNING THE HAIRCUT
Cutting hair requires practice so it is always better to leave the hair longer for the first few
haircuts until you become used to the length to which eace comb attachment cuts the hair.
ATTACHMENT COMB
• Attachment Comb #1 leaves 3mm(1/8inch)hair length.
• Attachment Comb #2 leaves 6mm(1/4inch)hair length.
• Attachment Comb #3 leaves 9mm(3/8inch)hair length.
• Attachment Comb #4 leaves 12mm(1/2 inch)hair length.
Each comb attachment is marked accordingly on its outside middle surface.
• To attach a comb,hold it with its teeth upeard and slide it noto and along the clipper blade
until the front of the comb firmly seats against the clipper blade.
• To remove the combsimply pull the comb upward and away form the clipper blade.
• For even cutting, allow the comb attachment/cutter to cut its way through the hair. Do not
force it through puickly. Also remenber to comb the hair frequently to remove trimmed hair
and to check for uneven strands.
STEP 1 - NAPE OF THE NECK
1. Attach comb attachment 3mm or 6mm.
2. Hold the clipper cutting edge pointed up and begin the haircut, starting at the centre of the
head at the base of the neck(see diagram 1).
3. Hold the clipper comfortably in your hand and hold lightly against the head with the comb
teenh pointing upward. Gradually and slowly lift the clipper working upwards and outwards,
through the hair trimming just a little at a time.
4. As you cut, gradually lift the hair clipper head towards you. Continue to cut the back area from
the bottom of the neckupwards to the top of the ears.
Diagram 1