Wiesenfield WIE-CCD-100 Bedienungsanleitung Seite 36

This screen allows users to set the protection level (in the range 0-8 OFF).
Press "↑" or "↓" to select the level. The higher the value, the higher the level can be.
4) Saving the settings
Press the "MENU" button to save the settings.
Tips:
When it comes to the light level setting mode, the range in which the door
•
will stay open is 15-23 and the range in which the door will close is 0-14. 0
means complete darkness and 23 means total brightness.
• If "Error" is displayed on the screen while in use, check the "Error Codes"
table.
• If the red indicator light flashes frequently, it means that an error has
occurred. Press the "MENU" button to wake up the screen and display the
error code.
If the "TIMER-TIMER" mode is used, the user may have to wait to see if the
•
device is working properly.
• The "LIGHT-LIGHT" mode can be tested by covering the light sensor. After a
few seconds, the door will begin to close. When the door is nearly closing,
uncover the light sensor and the door will be raised to its original position.
If the device is disconnected and reconnected to the power supply, the
•
controller will remain in sleep mode for 30 minutes until the "MENU" button
is pressed.
• After replacing the batteries, set the current time again and save the settings.
Manually closing/opening the door
Press and hold the "↓" button for 4 seconds - the door will close temporarily
•
(it will open after 3 minutes).
Press and hold the "↑" button for 4 seconds - the door will open temporarily
•
(it will close after 3 minutes).