Zenner IoT gateway smart Schnellstartanleitung

IoT gateway smart
Quick Start Guide
ZENNER International GmbH & Co. KG
Heinrich-Barth-Str. 29, D-66115 Saarbrücken
Phone +49 681 99 676-30
Fax +49 681 99 676-3100
Mail info@zenner.com
Web www.zenner.com
Web Provisioning
You can connect the IoT gateway smart to the Internet either via the WPS
function of your WLAN router or via the web interface of the gateway.
WPS function
Press and hold the "config" button for 5 seconds. The status LED will now
flash orange and green. Press the WPS button on your WLAN router within 2
minutes. The connection will now be established automatically and the
status LED will be green. If this is not successful, please use the web interface
to connect the gateway.
Web interface
When the device is in the initial state (status LED flashes orange, e.g. during
the first boot-up or after a reset), you can connect the gateway to your
desired WLAN network.
You will find the device "IoTGatewaySmart-XXXXXX" in the list of available
WLAN networks on your smartphone or PC. The WLAN password is located
on the label on the back of the device ("pw: xxxxxxxx").
After connecting to the "IoTGatewaySmart-XXXXXX", the setup page opens. If
the web page does not open automatically, please use your internet browser
(Firefox, Chrome, Safari) to open the web interface manually using the IP
address 192.168.4.1
Select the desired WLAN network and enter the corresponding password.
After that, the IoT gateway smart saves this connection information. The
setup is complete.
English
Overview
Status LED
Solid Green: The IoT gateway smart is connected to B.One Middleware.

Blinking Green: The IoT gateway smart is establishing the connection to

B.One Middleware.
Blinking Orange: Waiting for configuration (initial boot up).

Fast Blinking Orange: The IoT gateway smart is trying to connect to

Wi-Fi network.
Buttons
Config Button: For WPS function to connect to your chosen Wi-Fi.

Reset Button: Press and hold for 10 seconds to reset the IoT gateway

smart to factory default settings.
USB-C Port
The gateway can optionally be powered with a standard powerbank or

even a smartphone via the available USB-C port.
Resetting your IoT gateway smart
To perform a factory reset, press and hold the reset button of the IoT
gateway smart for 10 seconds. This will clear the cache of known Wi-Fi
configuration and credentials. Use a bent paper clip for this purpose, for
example.
Power Plug Adapter
The IoT gateway smart comes with an outlet adapter for the European Union
and a blank power Adapter cover.
Simply slide the adapter into the designated spot on the back of the housing.
Then plug the gateway into the power outlet.
Safety instructions
Only operate the device inside buildings and only in dry rooms. Avoid direct
sunlight and ensure sufficient ventilation.
Do not open the housing of the device under any circumstances. Opening
and/or improper repairs may put you in danger. Do not allow any liquids to
enter the interior.
Disconnect the unit from the power supply before cleaning.
Use a dry or slightly damp cloth for cleaning.
Make sure that the device does not get into the hands of children.
Please read the manual for further instructions.
www.mz-connect.com/shop/en
Status LED ("connect")
Config Button ("config")
Reset Button ("reset")
USB-C Port