Power Supply - MoMi LAMI Handbuch

Disassembling: Pull out the metal clip as shown on the drawing „B", this will disengage the locking
mechanism which will allow to pull out the seat frame from the base.
SEAT COVER AND HEADREST
Installation: pull the seat cover over the frame and fasten the Velcro fl aps on the back. To attach the
headrest, the Velcro fl ap should go through the loop located on the top of the seat cover.
Removal: to take off the seat cover simply detach the Velcro, and pull out the fabric of the metal frame.
CANOPY AND TOYS
Installation: To attach the toys to the canopy simply pull the Velcro fl ap through the two possible
loops. Once the toys are connected to the canopy fasten the clasps on the swing frame on both sides.
The canopy part with the elastic fi nish should go behind the seat, so that it overlaps the back of the
headrest area of the swing. The mosquito net can be quickly attached to the canopy with a zipper.
Removal: Pull out both clasps of the canopy to remove it.
NOTE: the seat cover has small fabric fl aps which reveal the metal frame. Thanks to this, the canopy
is more securely attached to the frame. After the canopy net has been removed, the fl aps should be
closed to hide access to the frame.
SAFETY BELT INSTRUCTION
Place the baby into the bouncer and remember to adjust the seat belt on both sides equally. The buc-
kle of the safety belts is located in the crotch support restraint. It can be easily accessed by pulling on
the Velcro attachment.
NOTE: Make sure that the safety belt is fi tted for the child.
WARNING: To ensure the safety of the child make sure that the safety belt is properly connected to
the buckle before using the bouncer.
MOTION LOCK
Push the motion lock down to lock the bouncer in the starting position. Pull the motion lock up to
unlock the rocking motion.
WARNING: do not try to engage the lock while the bouncer is in motion.

POWER SUPPLY

Plugin the adapter into the swing as shown in the picture. The socket is located on the inside of the base.
A. DC plug can be inserted into 100-240V ~ 50 / 60Hz AC power supply.
B. Adapter output parameters: voltage is 5V and current is 1A.
C. The adapter has a 2m long USB cable.
D. When the power lamp keeps fl ashing it signals a high voltage alarm – use a matchable adapter with
an output voltage of 5V and 1A.
• The AC adapter used with the product should be checked regularly for damage to the power cord,
plug, case, and other parts. In the event of such damage, the product should not be used until the
repair has been carried out.
• The product should be used only with the power supply recommended by the manufacturer.
• The adapter and cord are not toys and should not be accessible to children
• It is not recommended to connect the AC adapter with batteries in the battery compartment.
• The product should not be connected to more than the recommended number of power sources.
EN
13