Fame Audio MT Serie Bedienungsanleitung Seite 20

Installation:
Be sure to check the unit for damage before use. Use the original packaging or a suitable transport or
storage packaging to protect the product from dust, moisture, etc. when not in use.
During assembly, suitable protective equipment (in particular head protection, gloves and safety shoes)
must be worn and only suitable climbing aids (ladders, scaffolding, etc.) must be used. The responsibili-
ty for this lies solely with the installation company.
The installation may only be carried out by experts and only at mounting points with sufficient
load-bearing capacity, if necessary taking construction requirements into account. The fixing material
(screws, dowels, etc.) specified by the manufacturer in the assembly instructions must be used. Screw
connections must be secured against loosening by suitable measures.
Fixed or mobile installations shall be protected against falling by two independently acting devices.
Loose additional parts or parts which come loose must be able to be caught by suitable devices.
National regulations must be observed when using fasteners and fixing elements as well as slings. With
regard to the dimensioning of the securing devices, possible dynamic loads (jerking forces) must also
be taken into account.
ATTENTION! (Inspection measures)
After installation, check the suspension of the system consisting of bracket and
loudspeaker for secure fastening. The operator of loudspeaker systems (stationary
or mobile) is obliged to regularly inspect all system components or have them
inspected in accordance with the relevant national regulations and to have any
damage repaired immediately. Furthermore, we urgently recommend detailed
documentation of all inspection measures in test books or similar.
ATTENTION! (Load capacity)
When loudspeakers are longer or permanently used outdoors, wind loads, snow
and ice loads as well as thermal influences must be taken into account for the
stability and load-bearing capacity of structures and surfaces.
In particular, the load-bearing points of flown systems should be dimensioned with
sufficient safety reserves. The national regulations must be observed.
WARNING! (Risk of injury from overturning)
Improper installation can cause considerable injury and damage!
During transport and installation, ensure that only aids specified by the manufac-
turer (e.g. trolleys, stands, tripods, brackets, etc.) are used and always follow the
manufacturer's instructions!
Hint! (Special measures)
Special measures may also be required to prevent spectators from behaving dan-
gerously.
Tripods must not be set up in escape and rescue routes. When installing in traffic
routes, the required width of the paths and proper blocking and marking must be
ensured. When setting up and setting down
a special hazard. Suitable aids must be used for this purpose.
The national regulations must be observed.
Using this device with sinusoidal, square-wave or other measuring signals at higher levels
will cause serious damage to the device!