Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
2x Adapter Plugs with 4x USB
Charging Sockets per Plug
Item No. 2249700
Intended Use
The product is a power socket equipped with 4 USB-
A charging ports and enhanced protection against
accidental contact.
Warning labels in different languages are included
in the package. Stick the language label in your
language over or next to the language label on the
product.
The product is intended only for the connection to a
standard power socket with earth contact. Refer to
the technical data section to learn more about the
maximum permissible loads.
The product is only designed for indoor use. Keep
away from water and high-humidity sources and the
areas where these conditions occur (e.g. bathroom).
For safety and approval purposes, you must not re-
build and/or modify this product. If you use the prod-
uct for purposes other than those described above,
the product may be damaged. In addition, improper
use can result in short circuits, fires, electric shocks
or other hazards. Read the instructions carefully and
store them in a safe place. Make this product avail-
able to third parties only together with its operating
instructions.
This product complies with the statutory national and
European requirements. All company names and
product names are trademarks of their respective
owners. All rights reserved.
Delivery Content
•
2x USB charging adapters
•
Warning labels
•
Operating instructions
Up-to-Date Operating Instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of Symbols
The symbol with the lightning in the
triangle is used if there is a risk to your
health, e.g. due to an electric shock.
The symbol with the exclamation mark in
the triangle is used to indicate important
information in these operating instruc-
tions. Always read this information care-
fully.
The arrow symbol indicates special in-
formation and advice on operation.
The product is only intended to be
placed and used in dry, enclosed indoor
areas; it must not get damp or wet.
This symbol indicates that the product
meets the energy efficiency require-
ments for Class VI.
Safety Instructions
Read the operating instructions
carefully and especially observe
the safety information. If you do not
follow the safety instructions and
information on proper handling in
this manual, we assume no liability
for any resulting personal injury or
damage to property. Such cases will
invalidate the warranty/guarantee.
a) General
•
The unauthorized conversion and/or modification
of the product is not allowed for safety and ap-
proval reasons. Do not open/disassemble!
•
The product is designed in accordance with pro-
tection class I. Only a standard grounding mains
socket of the public supply grid (a wall socket, for
example) may be used as a power source.
•
The mains socket to which the product is con-
nected must be easily accessible.
•
The product is not a toy and should be kept out
of the reach of children. Position the product so it
is out of the reach of children.
•
The product is equipped with a protection against
accidental contact. An integrated mechanism will
release the holes of the receptacle only, if the two
prongs of a power plug are inserted into the two
holes at once.
•
Take special caution when children are around.
Children cannot recognize the danger arising
from the incorrect use of electrical devices. There
is a risk of a life-threatening electric shock!
•
Do not leave the packaging material lying around
carelessly as it may be a danger to children.
•
Handle the product with care; it can be damaged
by impacts, blows or falls even from a low height.
•
If you have any questions that are not answered
in this manual, please contact our technical ser-
vice or another specialist.
b) Connected Devices
•
Also observe the safety and operating instruc-
tions of any other devices which are connected
to the product.
c) Operating Location
•
The product may only be used in dry interiors;
it must not get damp or wet! Never position the
product in direct vicinity of a bathtub, shower,
bathroom, swimming pool, or similar. Lethal haz-
ard due to electric shock!
•
The product must not be exposed to extremes of
temperature, direct sunlight or strong vibrations.
Keep the product away from strong magnetic
fields generated by machines, electric motors or
loudspeakers.
•
Do not operate the device in environments where
there are high levels of dust, flammable gases,
vapours or solvents. There is a danger of fire and
explosion!
•
The device can warm up during use. Make sure
not to place it on sensitive surfaces.
•
Do not use this product in hospitals or medi-
cal institutions. Radio waves may interfere with
medical equipment. The same may also apply to
other areas.
d) Handling and Use
•
Never plug in, unplug or operate the product
when your hands are damp or wet. There is a risk
of a life-threatening electric shock! The same ap-
plies for the load that is plugged into the socket
of the product.
•
Never connect the product to the power supply
immediately after it has been transferred from
a cold room into a warm one (e.g. during trans-
port). The condensation that forms might destroy
the device. Moreover, there is danger of electric
shock! Allow the product to reach room tempera-
ture. Wait until the condensation has evaporated.
This might take several hours. Only then the
product may be plugged into the mains socket
and put into use.
•
Always use the gripping surface to pull a mains
plug out of the product.
•
Never overload the product. Note the maximum
permissible connected load in the chapter "Tech-
nical Data".
•
Do not connect in series! This can lead to an
overload of the product! There is a risk of fire!
•
Do not operate while covered! At higher con-
nected loads, the product becomes warm, which
can lead to overheating and potentially a fire if
covered!
•
Disconnect the product from the mains socket in
thunderstorms for reasons of safety.
•
Voltage-free only if unplugged.
•
Do not use the product if it is damaged. There
is a risk of a life-threatening electric shock! In
this case, dispose of the product in an environ-
mentally correct manner. Safe operation can no
longer be assumed if:
- the product shows visible signs of damage
- the product does not work at all or works
poorly (leaking smoke or a smell of burning,
audible cracking noises, discolouration to the
product or the adjacent surfaces)
- the product was stored under unfavourable
conditions
- it was exposed to heavy loads during trans-
port
•
Never pour any liquids above or next to the prod-
uct. You run the risk of causing a fire or a fatal
electric shock. If any liquid has still managed to
enter the device, immediately switch off the pow-
er supply to the mains socket at which the prod-
uct is connected (turn off the fuse/circuit breaker/
residual current operated circuit breaker of the
associated circuit). Only then can you unplug
the product from the mains socket and contact
a specialist. Do not use the product any longer.
•
Always pull the product out of the mains socket
(e.g. wall socket) before cleaning it or when the
device will not be in use for a long time (e.g. for
storage).
•
Use the product only in a temperate climate,
never in a tropical climate.
Control Elements
1
2
3
1. Socket
2. 4x USB charging ports
3. Plug
Technical Data
Manufacturer:
Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Commercial registration number:
HRB 3896
Model identifier:
MGQ0101USB
Input voltage ......................................... 230 V
Input AC frequency ............................... 50 Hz
Output voltage ...................................... 5,0 V
Output current ....................................... 3,6 A
Output power ........................................ 18,0 W
Average active efficiency ...................... 82,6 %
Efficiency at low load (10%) ................. 77,2 %
No load power consumption ................. 0,10 W
Rated power ......................................... max. 3680 W
Plug / socket type ................................. F (2-pin)
USB-A ports .......................................... 5 V/DC 3.6 A
max. 18 W (total)
Protection ............................................. over current
Operating conditions ............................. 0 to 40 ºC, 30 – 85 % RH (non-condensing)
Storage conditions ................................ 0 to 40 ºC, 30 – 85 % RH (non-condensing)
Dimensions ........................................... 84 x 64 x 58 mm
(L x W x H)
Weight .................................................. 101 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2022 by Conrad Electronic SE.
USB Charging Ports
The 4 USB charging ports can provide power to
devices connected via USB cable (e.g. charging of
mobile device), and do not serve as a data ports. See
section "Technical Data".
Maintenance and Cleaning
•
The product does not require any maintenance.
You should not open/disassemble it. Repair
or maintenance work must be carried out by a
specialist.
•
Before cleaning, turn the product off and discon-
nect it from the power supply. Disconnect con-
nected loads.
•
You can use a clean, dry, soft cloth for cleaning.
Dust can be very easily removed with a soft,
clean brush and a vacuum cleaner.
•
Do not use aggressive chemical or scouring
cleaning agents, as this may lead to discoloura-
tion or changes in the material on the surface.
Disposal
This symbol must appear on any electri-
cal and electronic equipment placed on
the EU market. This symbol indicates
that this device should not be disposed
of as unsorted municipal waste at the
end of its service life.
Owners of WEEE (Waste from Electri-
cal and Electronic Equipment) shall
dispose of it separately from unsorted
municipal waste. Spent batteries and
accumulators, which are not enclosed
by the WEEE, as well as lamps that can
be removed from the WEEE in a non-
destructive manner, must be removed
by end users from the WEEE in a non-
destructive manner before it is handed
over to a collection point.
Distributors of electrical and electronic equipment
are legally obliged to provide free take-back of
waste. Conrad provides the following return options
free of charge (more details on our website):
•
in our Conrad offices
•
at the Conrad collection points
•
at the collection points of public waste manage-
ment authorities or the collection points set up by
manufacturers or distributors within the meaning
of the ElektroG
End users are responsible for deleting personal data
from the WEEE to be disposed of.
It should be noted that different obligations about the
return or recycling of WEEE may apply in countries
outside of Germany.
*2249700_v3_1022_02_dh_m_en
Werbung
