Werbung
GB
SAFE
70207
DIRECTIONS FOR USE AND SAFETY INSTRUCTIONS
GENERAL NOTES
· Read the instructions carefully before use.
· Keep these instructions for future reference and include
these instructions if you pass on the product to third par-
ties.
· Use the product only for the intended use. Any other use
as well as modifi cations of the product have to be consi-
dered as improper use and could cause injuries or product
damages. The manufacturer will not be held responsible
for any damages resulting from such improper use.
· Not for commercial use.
SAFETY NOTES
⚠
WARNING
Life and accident risk for toddlers and kids! To
avoid danger of suffocation, keep packing ma-
terials away from babies and children. Risk of
suffocation due to packing material. Small parts
can be swallowed! Children often underestimate
the dangers!
knob
red button
INSERTING THE BATTERIES
1. Remove the cover between the turning knob and the digit
plate at the front (see illustration).
2. Take one of the two keys included and place it into the
lock. Turn it slightly to the left. Then turn the turning knob
to the right and now you can open the safe.
key
key pad
battery case
3. Open the battery case on the backside of the door, by
pushing the cover (OPEN) downwards in the direction of
arrow. Pls note the right polarity (+/-), if you insert the 4
x 1.5 V Mignon batteries.
4. Now close the safe and after taking out the key, place the
front cover back onto the lock. The safe is now activated.
OPENING THE SAFE
1. Input the preset code (the original set by the manufactu-
rer is 1, 5, 9). Press „E" to confi rm it or „C" to chancel it.
The green light will illuminate which will mean the safe
is able to opened. Turn the safe knob to the open position
within 5 seconds of the green light illuminating.
2. With each press of a number the yellow light will fl ash
and beep, indicating the safe confi rms this entry. If the
beeping and fl ashing doesn't stop when E is pressed, this
indicates the wrong code has been entered.
3. If the wrong code is entered 3 times, the safe will not
accept any entry within 20 seconds. If the wrong code is
entered another 3 times, the next entry can only be made
after 5 minutes.
LOCKING THE SAFE
Close the door of the safe while turning the knob.
Reset and change the user code
1. When the safe door is open, locate the red button on the
inside of the hinged edge of the door. Press and hold the
red button down. The yellow light will illuminate. Enter
your desired user code within 30 seconds (3-8 digits),
then press E to fi nish and store.
2. If the yellow light does not stop fl ashing/beeping, the safe
has not accepted your code. Please repeat the process.
3. If you want to change the users code, repeat the ope-
ration (1).
HOW TO USE THE OVERRIDE KEY
1. If you have forgotten the code, please remove the front cover
and proceed with opening the safe as described in Point 1.
Note: NEVER leave the reversal key in or near the safe!
CHANGING THE BATTERY
If both the red and green lights are on, this indicates that the
batteries needs to be replaced. Replace all 4 batteries with
the same type (see Technical Details).
3
Werbung
