Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Height adjustment of push handles
Insert push handles at least to the fi rst cross hole into the
frame tubing. Insert the fi xing screw from the inside and
tighten using the washer and star screw (pic. 4).
To change the height adjustment of the push handles,
loosen the fi xing screw by turning the star screw counter-
clockwise. Then lock the handle at the desired height, as
described above (pic. 5).
4
Adjusting the brakes
If braking is poor or too hard, the brake can be adjusted
either at the brake housing above (pic. 6) or using the
adjusting screw on the Bowden cable below (pic. 7) to
achieve the desired braking eff ect.
6
The brake is correctly adjusted when the brake lever as
well as the brake wires are free of play and the wheels
can be rotated without grinding noises when the brake
is released.
Braking | Parking
8
12
Drive Medical GmbH & Co. KG | As per: 12.07.2022 | Errors and alterations excepted
5
7
To brake when walking
with the rollator, pull both
brake handles upwards
with your hands (pic. 8).
Always brake slowly while
applying equal pressure
with both hands.
9
The braking eff ect can be impaired by wear and tear on
the tires. For this reason, regularly check the braking
eff ect.
Adjusting the backrest
10
Caution: Before each use, make sure that the sling
has been inserted correctly and that the two brackets
are fully tightened. Make sure that you fi t the sling the
right way (stitching facing outwards).
Sitting
11
Place the rollator on an even and solid surface. Then ap-
ply the brakes. The rollator must be stable and may not
slip. Only sit upright; do not lean backwards (pic. 11)!
Seated position permitted only as shown and against the
direction of movement (pic. 12)!
To apply the brakes/park
the rollator, press both
brake handles downwards
until they audibly click into
place (pic. 9)! To release
the brake, pull both brake
handles
upwards
once
again until they are re-
leased (brake handles are
in the middle position).
Position the sling by
inserting the fi xings
on each side into the
guides on the brackets
situated at the level of
the handles. Adjust the
supports to the height
required.
12
NOT PERMITTED!
Instructions for use NITRO SL
Werbung
Inhaltsverzeichnis
