Self-Cleaning Function; Error Detection - wad Elite DW000 Bedienungsanleitung

Self-cleaning function

This hair dryer has a self-cleaning function to clean its internal components.
How to activate the automatic cleaning? Once
1
the hair dryer is switched off, carefully turn the
external filter counter-clockwise and pull it out.
The motor will run, in reverse, for 10 seconds while
3
the other buttons are not active. At the end of the
self-cleaning session, replace the external filter and
switch on the dryer.
12
Press the air speed and temperature
2
buttons at the same time for 5 seconds.
5s 5s
If you want to stop automatic cleaning, turn the
4
power switch on and off. This function will stop
automatically and the dryer will operate normally.

Error detection

ERRORS LED 1 LED 2
Hardware surge protection Flashing Shutdown
Temperature sensor out of range Shutdown Flashing
Software protection Flashing Flashing
Voltage above upper range Flashing Flashing
Voltage below the lower range Flashing Flashing
Locked engine Flashing Flashing
Malfunctions Flashing Flashing
Generic malfunction Flashing Shutdown
LED 3 LED 4 LED 5 LED 6
Shutdown Shutdown Shutdown Shutdown
Shutdown Shutdown Shutdown Shutdown
Shutdown Shutdown Shutdown Shutdown
Flashing Shutdown Shutdown Shutdown
Flashing Flashing Shutdown Shutdown
Flashing Flashing Flashing Shutdown
Flashing Flashing Flashing Flashing
Flashing Shutdown Flashing Shutdown
13