Before Installation; Installation Steps - Vente Unique C-3188-1 DYONA Bedienungsanleitung

3. INSTALLATION

3.1 Before Installation


Open the packing cartons to check whether the bathtub has defects, and the availability of fittings.

Install the cap of switch, hand shower, faucet.

Put the bathtub into a pre-determined place.

The hot and cold water supply device should be located in a hiding place of bathtub body, through hose to
connect with hot and cold-water connection. (If poor water it should be installed water filtrating
equipment.)

Lead the drainpipe to the preformed floor drain. Then set the bathtub tube into the right place. Do not
extruding bending, chocking drainpipe, make sure the bailing smoothly.

Carefully hand tight the white drainpipe until stops. Do not over tighten. If possible, better to do it by
silicone or seal strips to avoid water leakage.

Put the plug into the socket.

Adjust the foot to make the bathtub at a horizontal position stabled.

3.2 Installation Steps


Open the package, and find a small box. Install the three switches, hand shower and faucet on bathtub.

Confirm the place of water, power and drainer. Install water pipe, drainer, and plug in right place.
12