Overview Of Basic Settings Menu - HYDAC HDA 5500-3-0-AC-000 Benutzerhandbuch

HDA 5500

7.2 Overview of basic settings menu

Menu point Setting
Primary display (PriM)
Value which is normally displayed:
Display filter (diSP)
Reset time (r.TiM)
Indicates how long in seconds the last peak / lowest value is
displayed for.
Input signal sensor 1 (inP.1)
Decimal place sensor 1 (dEc.1)
No. of decimal place(s) of the display of measured value of
sensor 1
Lower display range sensor 1 (LOr.1)
Lower limit of the display range of sensor 1
Measured value sensor 1
Lowest value sensor 1
Peak value sensor 1
Measured value sensor 2 (Pt 100 sensor)
Lowest value sensor 2 (Pt 100 sensor)
Peak value sensor 2 (Pt 100 sensor)
Display reacts slowly to measurement variations
(display delay approximately 1.3 s).
Display reacts at standard rate to measurement
variations (display delay approximately 0.6 s).
Display reacts quickly to measurement variations
(display delay approximately 0.3 s).
0..5 V
0..10 V
4..20 mA source
4..20 mA sink
User Manual
Setting range Default setting
SEn.1 SEn.1
Min.1
ToP.1
SEn.2
Min.2
ToP.2
SloW MEdi
MEdi
FAST
0..3600 0
5 V mA.S.
10 V
mA.r.
mA.S.
0..0.000 0.0
-999..9899 0
- 9 -