Remote Controller - MIVARDI Carp Scout Gebrauchsanweisung

REMoTE coNTRoLLER

The all-in-one remote controller was developed exclusively to control the Carp Scout boats. The device is equipped with a
large LCD display that shows all sailing and the boat status details. Real-time two-way data transfer increases user comfort.
Rc controls:
1. Main switch / confirmation
of menu selection
Press for 3 seconds to turn the
RC on / off. In the main menu,
use this button to confirm the
selected setting.
2. Menu navigation buttons
3. Menu navigation buttons
4. LcD display backlight
Press to turn the backlight
on / off. Hold down the button to adjust the backlight
intensity.
5. Activation / deactivation of the audible warning
signals
Signals are provided when: the batteries are low, the
bait hopper is opened, the rig hooks are released, the
destination point is reached in GPS navigation mode,
the signal is lost.
6. GPS
Press the button to switch between the main screen
and the GPS menu.
7. AUTo mode
Press the button to activate the automatic sailing
mode. After switching on the AUTO mode, the boat
maintains its current sailing direction. In AUTO
mode, you can use the joystick to adjust the sailing
direction.
8. boat lights
Use this button to turn on / off the boat lights.
9. Rig releasing button
Press the rig releasing button to open the left rig
holder. Press it again to open the right rig holder.
Releasing of the rig (opening the rig holder) is
confirmed by an audible signal on the remote cont-
roller and by the flashing lights on the boat. Then the
empty rig holder is shown in the symbolic drawing of
the boat on the display. By pressing the rig release
button for the third time, you reset the displayed
status of the rig holders. When the rig holder on the
12 |
MIVARDI
boat releases your rig then it automatically comes
back come back to the starting position within one or
two seconds.
10. bait hopper button
Press the bait hopper button to open the left bait
hopper. Press again to open the right hopper. The
opening of each hopper is confirmed by an audible
signal on the controller and by the flashing lights on
the boat. Then the empty bait hopper is shown in
the symbolic drawing of the boat on the display. By
pressing the bait hopper button for the third time,
you reset the displayed status of the bait hoppers.
The door of the bait hoppers must be always closed
manually.
11. SET
This button is used to save the current location of
the boat to the selected memory position in the GPS
menu or to delete a saved location from the selected
memory position.
12. ESc
Press this button to leave the GPS menu.
13. Tlačítka + a –
Use these buttons to select the memory position in
the GPS menu.
14. Tlačítka + a –
Use these buttons to select the memory position in
the GPS menu.
15. Go
Press this button to start an automatic sailing with
GPS navigation to the destination point, stored under
the currently selected memory position in the GPS
menu. During automatic GPS navigation, you can
press GO to interrupt automatic navigation and return
to manual driving.