Operating - Thermrup HP622 Gebrauchsanweisung

4.1 Operating with power bank
 Plug the USB connector of the cable into the USB
socket of the powerbank.
Briefly press the power button on the controller to
turn on the first level.
Next, if necessary, press the power key again to set
the desired temperature level (1-2-3, red-green-blue).
Each single key touch increases the temperature by one level.
The 1st level is the warmest level. (red LED indicator lights up).
The 2nd stage is the middle stage. (green LED indicator lights up).
The 3rd stage is the lowest stage. (blue LED indicator lights up).

 When the blue level is reached and the ON/OFF button is pressed again, the
heating function is switched off and the LED indicators no longer light up. After
100 minutes of continuous operation, the heating pad will automatically turn
off, restart your powerbank to continue.
!! Discontinue use if you see reddening of the skin or if the pad becomes
uncomfortably hot! Excessive heat can cause burns.
4.2 mains operation
 Connect the supplied extension cable to
the connection cable of the pad.
 Plug the USB connector of the extension
cable into the supplied power supply.
 Press the power button of the controller
short to switch on the controller. Then
press the power button briefly to set the
desired temperature level (1-2-3, red -
green-blue).
 Press the power button until all of the LED off to switch off the controller.
 After use, remove the extension cord from the
charger.
*** Please use only the supplied charger. ***
8