Werbung
Tube
User manual
Thank you for purchasing the Lightpro Tube.
This document contains the required information for
correct, efficient and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Tube can be used in combination with
the Lightpro Juno Tube. It can be placed in the ground
using the supplied ground spike, but can also be used
for wall mounting. This product may only be used as
outdoor lighting in combination with the Lightpro
12-volt system. Any alterations made to the product
may have consequences for the safety, guarantee and
correct functioning of the product and/or other parts of
the system.
SPECIFICATIONS
Product
Article number
Dimensions (h x Ø)
PACKAGING CONTENT
[Figure A]
1. Tube
2. Cover caps of the pipe
3. Coupling
4. Mounting of the ground spike
5. Dowel
6. Spacer
7. Cover caps
8. Mounting blocks
9. Screws
10. Ground spike
11. Allen key
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
Tube
215A
1200 x 20 mm
INSTALLATION
When assembling the tube [1], it may occur that
the set screws [1A] are screwed too far into the tube. If
necessary, open them carefully, after which the parts
will slide into each other properly.
[Figure B]
1. Fasten the pipes [1] to each other with the coupling
piece [3] and tighten the set screws [1A] with the
Allen key [11B].
2. Place the tube covers [2] on the tube (or only at the
top in case of ground mounting).
OPTION 1: INSTALLATION ON THE GROUND.
[Figure B]
1. Place the mounting of the ground spike [4] on the
pipe and tighten the set screws [1A] with the Allen
key [11B].
2. Mount the ground spike [10] on the ground spike
attachment [4].
OPTION 2: WALL-MOUNTED INSTALLATION.
The Tube can be placed horizontally, vertically and
diagonally on the wall.
[Figure C]
Place the two mounting blocks [8] at the desired
location.
1. Screw the screw [9] into the wall at the desired
location. If necessary, use the supplied plugs [5].
2. Place the distance bush [6] over the screw [9].
3. Screw the mounting block [8] onto the screw [9].
[Figure D]
1. Slide the tube [1] through one of the mounting blocks
[8].
2. Then slide the mounting blocks [8] for the
spotlight(s) onto the tube [1].
3. Push the tube [1] further to the second mounting
block [8] on the wall.
4. Ensure that the cable guide is at the back and tighten
the set screw [8A] at the front of the mounting block
[8] using the Allen key [11A].
5. Place the protective cap [7] on the front of the
mounting blocks
Werbung
