Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
PB-19C Power Bank PD 18 W 20000 mAh
Item No. 2380474
Intended Use
The product is a portable power bank with fast charging, and can supply up to 18 W of power. The built-in
rechargeable battery is charged via USB. The product is protected against overcharging, over-discharging,
and overload.
Contact with moisture must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use
can result in short circuits, fires, electric shocks or other hazards. Read the instructions carefully and store
them in a safe place. Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and prod-
uct names are trademarks of their respective owners. All rights reserved.
Delivery Content
•
Power bank
•
Micro USB cable (27 cm)
•
USB-C
cable (27 cm)
®
•
Operating instructions
Up-to-Date Operating Instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of Symbols
The symbol with the lightning in the
triangle is used if there is a risk to your
health, e.g. due to an electric shock.
The symbol with the exclamation mark
in the triangle is used to indicate impor-
tant information in these operating in-
structions. Always read this information
carefully.
The arrow symbol indicates special in-
formation and advice on operation.
Safety Instructions
Read the operating instructions
carefully and especially observe the
safety information. If you do not fol-
low the safety instructions and infor-
mation on proper handling in this
manual, we assume no liability for
any resulting personal injury or
damage to property. Such cases will
invalidate the warranty/guarantee.
a) General Information
•
The device is not a toy. Keep it out of the reach
of children and pets.
•
Do not leave packaging material lying around
carelessly. This may become dangerous play-
ing material for children.
•
Protect the appliance from extreme tempera-
tures, direct sunlight, strong jolts, high humid-
ity, moisture, flammable gases, steam and
solvents.
•
Do not place the product under any mechani-
cal stress.
•
If it is no longer possible to operate the prod-
uct safely, take it out of operation and protect it
from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor
ambient conditions or
- has been subjected to any serious
transport-related stresses.
•
Please handle the product carefully. Jolts, im-
pacts or a fall even from a low height can dam-
age the product.
•
Consult an expert when in doubt about the op-
eration, safety or connection of the appliance.
•
Maintenance, modifications and repairs must
only be completed by a technician or an author-
ised repair centre.
•
If you have questions which remain unan-
swered by these operating instructions, contact
our technical support service or other technical
personnel.
b) Power Bank
•
Make sure that the cable is not pinched, kinked
or damaged by sharp edges.
•
Never use the product immediately after it has
been brought from a cold room into a warm one.
The condensation that forms might destroy the
product. Allow the product to reach room tem-
perature before connecting it and putting it to
use. This may take several hours.
•
Never leave the product unattended during use.
•
The housing warms up during use. Ensure that
there is sufficient ventilation. Do not cover the
housing!
•
Do not store the product in a heated vehicle.
Avoid excessive heat (max. 35 °C). Observe
the information in the "Technical data" section.
•
Store the product in a cool, dry place when it
is not in use.
•
Do not short-circuit the USB inputs/outputs.
c) Connected Devices
•
Also observe the safety and operating instruc-
tions of any other devices which are connected
to the product.
d) LiPo Rechargeable Battery
•
The rechargeable battery is permanently built
into the product and cannot be replaced.
•
Never damage the rechargeable battery.
Damaging the casing of the rechargeable bat-
tery might cause an explosion or a fire! Unlike
conventional batteries/rechargeable batteries
(e.g. AA or AAA type), the casing of the LiPo
rechargeable battery does not consist of a thin
sheet but rather a sensitive plastic film only.
•
Never short-circuit the contacts of the recharge-
able battery. Do not throw the battery or the
product into fire. There is a danger of fire and
explosion!
•
Charge the rechargeable battery regularly, even
if you do are not using the product. Due to the
rechargeable battery technology being used,
you do not need to discharge the rechargeable
battery first.
•
Never charge the rechargeable battery of the
product unattended.
•
When charging, place the product on a sur-
face that is not heat-sensitive. It is normal that
a certain amount of heat is generated during
charging.
•
Do not charge the power bank and charge
any external devices at the same time! This
may result in damage due to overheating.
•
Do not charge the power bank using a
USB 2.0/3.0 port on your computer. The cur-
rent supplied by these ports may not be suf-
ficient, and may damage the computer.
Operating Elements
1
2
3
4
5
6
Charging the Power Bank
•
Connect an included cable into the Micro USB input (3) or the USB-C
•
Connect the other end of the cable to a suitable USB power source.
LED Battery Status Indicators
The LED battery status indicators (1) show you how much power is left in the bank. If needed press the
power button (2) once to light the indicators up. Each LED represents 25 % of charge.
Charging Mobile Devices
•
Connect the included charging cable or mobile device cable to a charging output port.
•
The LED battery status indicators will turn off after all devices have been disconnected from the charger.
You can charge up to 3 devices at the same time. The total charging output is 18 W maximum
and will be shared between each connected device.
Resetting
Reset the power bank if it does not work properly.
•
Disconnect all devices from the power bank.
•
Press and hold the power button for 9-10 seconds to activate the resetting mode. The indicator light
flashes.
•
Charge the power bank for several seconds.
The power bank is reset and ready to charge connected devices again.
Care and Cleaning
•
Disconnect the product from any devices and power supply before cleaning.
•
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can
cause damage to the housing and malfunctioning.
•
Clean the product with a dry, fibre-free cloth.
Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU market.
This symbol indicates that this device should not be disposed of as unsorted municipal waste
at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separate-
ly from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by
the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner,
must be removed by end users from the WEEE in a non-destructive manner before it is handed
over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste.
Conrad provides the following return options free of charge (more details on our website):
•
in our Conrad offices
•
at the Conrad collection points
•
at the collection points of public waste management authorities or the collection points set up by manu-
facturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries
outside of Germany.
Technical Data
Input voltage/current ............................. Micro USB: 5 V 2 A
USB-C
Output voltage/current .......................... USB-A output 2 (orange): 5 V 3 A; 9 V 2 A; 12 V 1.5 A
USB-A output 1: 5 V 2.4 A
USB-C
input/output ............................. 5 V 3 A; 9 V 2 A; PD 18 W max.
®
Operating/Storage conditions ............... 0 to +45 ºC, < 80 % RH (non-condensing)
Battery .................................................. LiPo 20000 mAh 74 Wh
Charging time (empty to full) ................ Micro USB: 5 V 2 A (12.5 hrs)
Type-C
Type-C
Dimensions (L x W x H) ........................ 140 x 69 x 27 mm
Weight .................................................. 366 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2023 by Conrad Electronic SE.
1 LED battery status indicators
2 Power button
Press once to show the battery status.
Press twice to deactivate the output power.
3 Micro USB input
4 USB-A output 1
5 USB-C
input/output
®
6 USB-A output 2, fast charge (orange)
input (5) on your power bank.
®
: 5 V 3 A; 9 V 2 A; PD 18 W max
®
: 5 V 3 A (8.3 hrs)
®
: PD 18 W (5.5 hrs)
®
*2380474_v2_0123_02_dm_mh_en
Werbung
