RONDELL RDE-1950 Betriebsanweisung Seite 8

ENGLISH
WINE COOLER RDE-1950
The Wine cooler is designed to store wine, with automatic mainte-
nance of the set temperature using the controller.
DESCRIPTION
1. Body
2. Fan
3. Fan grid
4. Shelf (8 pcs.)
5. Ventilation openings
6. Legs
7. Upper door hinge
8. Сooler door
9. Gasket
10. Lower door hinge
11. Control panel
12. Control panel unlock button
13. Button for turning on/off lighting, switching temperature
measurement units
14. Display for temperature indications
15. Temperature increase button
16. Temperature decrease button
ATTENTION!
For additional protection against possible electric shock it is
reasonable to install in the power supply circuit a residual cur-
rent device (RCD) with nominal operation current not exceeding
30 mA, to install the RCD, contact a specialist.
SAFETY MEASURES
Read this instruction manual carefully before using the unit and
keep it for the whole operation period. Use the wine cooler only
for its intended purpose, as described in this manual. Mishandling
the cooler can lead to its breakage and cause harm to the user or
damage to his/her property.
This unit is intended for use in domestic and similar conditions:
– in kitchen areas for staff in shops, offices and other indus-
trial conditions;
– in farm buildings and by clients in hotels, motels and other res-
idential-type infrastructure;
– in the accommodation conditions "bed and breakfast";
– in public catering and similar conditions unrelated to trade.
•
This unit is not intended to be used by people with physical,
sensory or mental disabilities (including children) or by persons
lacking experience or knowledge if they are not under super-
vision of persons who are responsible for their safety or if they
are not instructed by these persons on the usage of the unit.
Children should be supervised to avoid playing with the unit.
•
When placing the wine cooler, make sure that there is at least
15 cm of free space on the sides and behind the wine chiller
cabinet, as this is the main heat outlet. This will ensure suffi-
cient ventilation.
ATTENTION! Do not block the ventilation openings located in the
unit body or in the built-in construction.
•
Install the unit on a flat, stable surface away from sources of
moisture, heat and open flame so that access to the mains
socket is always free.
•
Install the cooler away from direct sunlight.
•
When placing the unit, make sure that it is installed vertically,
not at an angle, and not upside down.
•
Before plugging the cooler in make sure that the operating volt-
age of the unit corresponds to the voltage of your mains.
•
Do not use the unit if the power cord is damaged. If the power
cord is damaged, it must be replaced by the manufacturer,
service department or similar qualified personnel to avoid
potential injuries.
•
The power cord is equipped with a "euro plug"; plug it into the
socket with reliable grounding contact.
•
To avoid fire, do not use adapters for connecting the unit to
the mains.
•
Never pull the cord to disconnect the unit from the socket.
Grasp the plug and pull it out of the socket.
•
Do not touch the power cord, the power cord plug and the wine
cooler body with wet hands.
•
Do not use electrical appliances inside the beverage storage
compartments of the unit unless they are of the type recom-
mended by the manufacturer.
•
Do not store explosive objects, in particular aerosol cans with
flammable filler in the unit.
•
Disconnect the wine cooler from the mains while it is being
cleaned inside and outside, while moving it to another place,
washing the floor under it, troubleshooting.
•
Do not use the cooler outdoors.
•
Do not put anything on the wine cooler.
•
For children safety reasons do not leave unattended polyeth-
ylene bags used as packaging.
ATTENTION! Do not allow children to play with polyethylene bags
or packaging film. Danger of suffocation!
ATTENTION! Do not use electrical appliances inside food stor-
age compartments, except those recommended by the man-
ufacturer.
•
In order to avoid potential injuries, it is forbidden to repair the
unit yourself. Do not disassemble the unit by yourself, if any
malfunction is detected or after the unit was dropped, unplug
the unit and apply to any authorized service center from the
contact address list given in the warranty certificate and on the
website www.rondell.ru.
•
Transport the unit in the original packaging only.
•
Keep the unit in a dry cool place out of reach of children and
people with disabilities.
8