Placing Batteries In The Remote Control; Listening Modes - nedis SPSB200BK Kurzanleitung

• Keep the product away from heat sources. Do not place the product on hot
surfaces or near open flames.
• Before use, always check that the mains voltage is the same as the voltage on
the rating plate of the product.
• Unplug the product if you do not plan on using the product for an extended
period of time.
Installation to the wall (image D)
1. Drill 2 holes, as indicated in image D.
Insert plugs into the holes.
4
2. Insert the screws A
3. Mount the product onto the screws A
Connecting the product (image E)
Connect the cables to the product as shown in image E.

Placing batteries in the remote control

1. Open the battery compartment on the back of the remote.
2. Insert the two required AAA batteries (not included) into the battery
compartment.
3. Close the battery compartment.
Press and hold the Power/Mode button B

Listening modes

To change listening mode:
• Press the music mode button C
to music.
• Press the movie mode button C
watching movies.
Input modes
To change input mode:
• Press the Power/Mode button B
q into the plugs.
to optimize the audio settings for listening
5
to optimize the audio settings for
w
or the mode button C
1
using the mounting holes A
q
1 to switch on the product.
8
7
8 .