Cleaning, Care & Maintenance - NISBETS ESSENTIALS CH732 Bedienungsanleitung

Cleaning, Care & Maintenance
WARNING: Always turn off and disconnect the appliance from the power supply before
cleaning.
Always allow the appliance to cool before emptying or cleaning.
• Wipe down the exterior of the appliance with a damp cloth.
• Some cleaning agents may cause damage when used for a prolonged period on stainless steel. Use a
suitable stainless steel cleaner. Daily cleaning is recommended.
• Wash all removable parts in warm, soapy water.
• Dry the exterior thoroughly.
De-scaling
To maintain energy efficiency and prolong the life of the appliance, regular de-scaling is needed.
• Pour a solution of neutral cleaner and water into the appliance.
• Brush gently with a soft brush.
• Discard the solution and flush out thoroughly with clean water to remove any solution residue.
• Wipe dry the appliance, especially the bottom part of the water tank.
Note: Use a suitable cleaner and always follow the instructions on the cleaner container.
Nisbets Essentials recommend that this appliance is de-scaled every 3 months or more
often in hard water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Thermal cut-out switch has
activated
The thermostat has not been set
correctly
The heating element has failed
CH732_ML_A5_v1_20220428.indb 5 CH732_ML_A5_v1_20220428.indb 5
Probable Cause
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Reset Thermal cut-out switch (Page 4)
Set the thermostat to a higher temperature
Replace heating element
EN
Solution
5
2022/4/28 10:25 2022/4/28 10:25