Bedienungsanleitung - Comra delta Bedienungsanleitung

Bedienungsanleitung

Funktionen der START/STOP-Taste
When first plu ged into the mains only the START/STOP light will come on at
S T A R T / S T O P F R E Q U E N C Y
half-power to show that the Delta is plugged in and is in Standby Mode.
When the START/STOP button is pressed and held the Delta will power-up into
Normal Ready State. The FREQUENCY and TIME buttons will glow brightly, and
the currently selected settings are indicated by the orange LEDs.
Whenever the START/STOP button is pressed and held and the Delta is
not running a program it will power-down to Standby Mode again with the
START/STOP button light at half-power.
From the Normal Ready State if the START/STOP button is pressed briefly
the selected program will start and the button will pulse to show that the
program is active.
If the START/STOP button is pressed briefly during a running pro ram the
Delta will pause the program, and the START/STOP light will blink on and
off to show Pause Mode. If the START/STOP button is pressed again
it will resume the program for the correct remaining time, and the
START/STOP light will return to slow running pulsation.
If the START/STOP button is pressed and then held during a
running program or during a paused program the program will
finish and the Delta will return to the Normal Ready State, and
will reset to the last run program settings. The Delta will
remember its last run program for each Terminal.
ULTRASOUND Button
Press for ON/OFF. (Available only
S T A R T / S T O P F R E Q U E N C Y T I M E U LT R A S O U N D U LT R A S O U N D ( O F F )
with Medical & Aesthetic Terminals)
If the Terminal is removed during Standby
Mode, or Normal Ready State, the Delta
will power-down to the Off State, until a
Terminal is reinserted into the handle.
Do NOT remove a Terminal whilst
running a program.
If the Delta is not being used
for a period of more than 24
hours it is recommended to
unplug the power supply
unit from the mains.
T I M E U LT R A S O U N D U LT R A S O U N D ( O F F ) E J E C T
E J E C T
vor dem Start...
1
S T A R T / S T O P
Press to cycle through to the
S T A R T / S T O P F R E Q U E N C Y T I M E
desired time.
During a running program the LEDs
showing the time will change to
indicate the full minutes remaining.
TERMINAL EJECT Button
Press and hold then remove terminal.
| |
15
2
3
FREQUENCY Button
Press to cycle through to the
F R E Q U E N C Y T I M E U LT R A S O U N D U LT R A S O U N D ( O F F )
desired frequency.
TIME Button
U LT R A S O U N D U LT R A S O U N D ( O F F ) E J E C T
4
E J E C T