Werbung
GB
Avior
User manual
Thank you for purchasing the Lightpro Avior.
This document contains the required information for
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
The Lightpro Avior is an LED spot for outdoor use. The
the included screws, or be placed in the ground with
the included spike. This product may only be used
as outdoor lighting in combination with the Lightpro
12-volt system. Any alterations made to the product
may have consequences for the safety, warranty, and
correct functioning of the product and/or other parts
of the system.
Product
Article number
Power (max.)
Dimensions (H x W x D)
Protection class
Ambient temperature
Cable length
Dimmable
[Figure A]
1. Fixture Avior
2. Ground spike
3. Screws
4. Plugs
5. Lightpro connector
6. Hex key
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us. E-mail: info@
lightpro.nl
Lightpro Avior
181S
16W
125 x 180 x 68 mm
IP44
-20°C to 50°C
1m
Yes, with built-in dimmer
1. Remove the screw from the base using the included
hex key (Figure A [6]).
[Figure C]
• Install the base onto the underground with the
included screws.
If necessary, drill a hole in the underground and use
the included plugs.
[Figure D]
2. Place the screw in the base.
4. Fasten the screw using the included hex key
(Figure A [6]).
[Figure E]
1. Place the spike underneath the base.
2. Properly fasten the spike.
4. Fasten the screw using the included hex key
(Figure A [6]).
light output can be set to 6 different levels.
[Figure F]
• Push the button to set the desired light output.
Werbung
