Required Tools - Proplus 560084 Gebrauchsanleitung

OPERATING INSTRUCTIONS
1. PARTS
2 x
2. ASSEMBLY
A) Adjust the wire mesh assembly to the appropriate size to
fit your vehicle. Use the plastic clips to fix the wire mesh
and slide mesh assembly together.
A
C) Assembly the screw, then fix the wire mesh holder on
wire mesh assembly. Assemble the top plastic feet on
the tubes.
C
Width: Min. 91 cm,
max. 131 cm
1 x
2 x
B) Connect the support bar and upper tube by adjustable
D) Assembly the long screw and bottom plastic feet on the
support bar. Adjust the height by the adjustable screw.
Use the long screw to tighten the guard against the floor
of the vehicle.
Hight: Min. 47 cm,
max. 108 cm
4
2 x
2 x
2 x
2 x
screw. Insert the clip into the mesh holder, to pass the
tube through the wire mesh holder.
B
D

REQUIRED TOOLS

Phillips screwdriver
4 x 8 x 4 x
4 x
2 x
Allen key
NOT INCLUDED