ATLASIO SHD SMARTER HOHENVERSTELLBARER SCHREIBTISCH Montageanleitung Seite 14

C O N T R O L L E R I N T R O D U C T I O N
Memory Position
Reset
Roused
Hot Over-heating protection
E10 Sensorless alarm
E20 Overload protection
E02 Rebound protection
E32 Overvoltage alarm
E31 Undervoltage alarm
E60 Step out alarm
Breaking protection
Change Displayed Unit
Change Brightness
Collision Force
Detection
14
Press to go up and display real height.
Press to lower and display real height.
Press until 1 appears, release the button, it runs to corresponding height and displays
current position.
Press until 2 appears, release the button, it runs to corresponding height and displays
current position.
Press until 3 appears, release the button, it runs to corresponding height and displays
current position.
Sit-Stand Reminder / Timer. Press
to adjust time. Press any button to save or wait three seconds to save automatically. To turn off reminder,
press button, wait two seconds, press the
Save button, used to enter the save height function.
After press, the interface flashes and set memory position, press
release button and it displays current height.
Long press for 5 seconds, display RES and press still, it goes down to the lowest
and rebound certain height, reset finish and show basic height.
10 seconds auto screen, Long Press
PROTECTION MODE (AUTO LOCK SCREEN MODE)
It alarms when continuously working for 2 minutes.
Re-powered on and waiting for at least 18 minutes before height adjustment.
It alarms when motor sensor can't be detected. Power off first.
Check the connecting of motor and control box,and then re-power on.
Overload alarm. If alarming when desk going up, remove the stuff on the desk and try again.
If alarming when desk going down, power off first, remove the stuff on the desk and re-power on.
It alarms when vibrated, collided or inclined in desk moving. Check if there is vibrating, obstacles
or incline. If no issues above, do the reset process and use it again.
It alarms when voltage is higher than required value. Power off first.
Check whether the connection between power and control box is OK. Power on again.
It alarms when voltage is lower than required value. Power off first.
Check whether the connection between power and control box is OK. Power on again.
It alarms when height difference between left leg and right leg exceeds the set value.
Power off first. Check whether the left leg and the right leg are in the same height.
If not, re-redo process 4 to make them in same height. Power on again.
It stops and enters protection state when motor lines or manual control lines are removed
or disconnected accidentally; back to normal after reconnected and alarm cleared.
ENGINEERING MODE
Long press the button, "M--" shows and flashes. Press
Press to select. Press
Press to save your choice.
Long press the button, "S--" shows and flashes. Press
Press or to switch to "br". Press
Normal (N) or High (H) brightness. Press
Long press the button, "M--" shows and flashes. Press
Press or to switch to "CF". Press
Normal (N) or Heavy (H) collision force detection. Press
to activate the function. Wait two seconds, press
button to "0".
for 3 seconds to wake up.
or to switch between "SI" (metric) or "In" (imperial).
to select. Press
to save your choice.
to select. Press
until H1 appears,
again and the display shows "Un".
again and the display shows "Un".
or to switch between Low (L),
again and the display shows "Un".
or to switch between "OFF", Low (L),
to save your choice.
or button