Herunterladen Inhalt Inhalt Diese Seite drucken

Sicherheitshinweise; Wartung Und Pflege; Safety Instructions; Care And Maintenance - ELMEKO MSE 20 Montage- Und Betriebsanleitung

Vorschau ausblenden Andere Handbücher für MSE 20:
Inhaltsverzeichnis

Werbung

SICHERHEITSHINWEISE

Die Installation darf nur von autorisiertem Fachpersonal vorgenommen werden. Die landesüblichen
Richtlinien sind gemäß IEC 60364 einzuhalten
Die technischen Daten auf dem Typenschild und in dieser Anleitung sind zu beachten
Der Anschluss erfolgt je nach Gerätevariante an 24 V DC oder 12 V DC
Anschlusskabel sind nur als Kupferleitungen zulässig
Die maximale Umgebungstemperatur von bis zu 55 °C ist zu berücksichtigen
Die Umgebung des Geräts darf max. Verschmutzungsgrad 2 entsprechen
Vorschriften des EVU sind zu beachten
Bei Beschädigung des Gehäuses oder der Anschlussleitung Spannung abschalten und alle Stecker abziehen
Achtung! Beim Öffnen des Gerätes erlischt die Garantie
Schutzmaßnahmen nach VDE 0100 sind sicherzustellen
Bei der Herstellung von Montageausschnitten und Bohrungen ist geeignete Schutzausrüstung zu tragen
Luftein- und Luftaustrittsöffnungen des Gerätes dürfen nicht abgedeckt werden
Stellen Sie vor der Montage sicher, dass der Schaltschrank hermetisch dicht versiegelt ist, ansonsten tritt später
während des Betriebs eine erhöhte Kondensatbildung auf
Installation must only be carried out by qualified electrical technicians in observation of the respective national power
supply guidelines (IEC 60364)
The technical specifications on the identification plate and in this manual, must be observed
Supply voltage is 24 V DC or 12 V DC, depending on the device variant
Connection cables only as copper conductors only
Taking into account the maximum surrounding air temperature rating of 55 °C
The environment of the device may be maximum with pollution degree 2
If the housing, or wire is damaged, switch off the voltage supply and disconnect all plugs
Attention! Opening the case will void guarantee
The safety measures according to VDE 0100 have to be ensured
Wear protective gear when cutting the mounting cut out and drilling the fastening holes
The air inlet and outlet openings to the unit must not be covered
Before mounting, make sure that the enclosure is hermetically sealed, otherwise increased condensation will occur later
during operation

WARTUNG UND PFLEGE

Das Entfeuchtungsgerät ist wartungsarm.
Führen Sie in regelmäßigen Abständen eine Sichtprüfung an dem Lüfter durch.
The dehumidifier is low-maintenance
Regularly perform a visual inspection at the fan
Die Entsorgung muss gemäß den jeweiligen nationalen gesetzlichen Bestimmungen erfolgen.
The disposal is to occur according to the respective national regulations.
WEEE-Reg.-Nr.: DE 78723147
9

SAFETY INSTRUCTIONS

CARE AND MAINTENANCE

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

40 me2 52l40 me2 82l

Inhaltsverzeichnis