Easy Camp Blur 680229 Bedienungsanleitung Seite 2

I N ST R U C T I O N M A N UA L I N ST R U C T I O N M A N UA L
1. LED bulb light chain w/ 15 bulbs, light chain: 210 cm, cord: 200 cm
2. Battery box for 3 x AA batteries (batteries not included)
3. Power button
1. Installation and use
Use of the lamp:
• Lamp can be powered by 3 x AA batteries (not included).
• Turn the light chain on/off using the power button (3) .
• Light chain can be hung by lashing it around a tent pole, a tree, a
clothesline or similar.
• The light chain is water resistant to IP44 .
2. Cleaning and maintenance
Light chain can be cleaned with water or a damp rag .
Do not use corrosive liquids to clean the lamp as this might damage the light chain .
3. Light Source: LED
Light source and control gear is not replaceable. This would introduce weak points in the construction, that could reduce the
lifetime of the product.
4. Disassembly and disposal
Instruction for removal of light source and control gear by market surveillance authorities:
1. Instruction for removal of light source and control gear by market surveillance authorities:Remove the light source from the
bulbs by removing the tape from the cord and light bulb and pull the cord and light source to remove the light bulb.
2. Cut needed wires to remove the required components for testing.
Instruction for disassembly of lamp for disposal of components when lamp has reached the end of its usable life:
- See steps 1-2 above
3. Remove batteries from the battery box (2) and dispose of the batteries according to local regulations .
4. Cut the wires in the battery box and remove the circuit board.
Dispose of the circuit board & electric wires according to local regulations .
5. Dispose of polycarbonate and other plastic components according to local regulations.
Technical data:
4.5V , 0.37 mA
Class 3 appliance
Degree of protection: The product is waterproof to IP44
Easy Camp Customer Service
e-mail: info@easycamp.com
Tel.: +45 69 15 20 17
easycamp.com